6100CR Refrigerated Sampler - Isco

6100CR Refrigerated Sampler
Section 2 Programming
stop before the programmed number of sample events if
there are not enough empty bottles remaining.
If no entry is made, the sampler will time out and return to
standby.
If you chose not to enter a start time in the Program
sequence, the sampling program will start immediately
after you enter the bottle to start on. The sampler may or
may not take a sample at this time, depending on how it is
programmed.
If you chose to enter a start time in the Program sequence
and the time you entered has not passed when you press
the Run key, the program will start at the time you
entered.
If you entered a start time in the Program sequence but the start
time has passed by the time you pressed the Run key, the following
screen will appear:
*PAST START TIME*
Followed by:
CHANGE START TIME?
YES NO
2. If you select NO, the start time will become the present
time and the program will start immediately. See Section
2.6, Active State Displays. Again, whether or not a sample
is actually taken at this time depends on other choices you
made in programming.
3. If you select YES, the sampler will ask you to enter a new
start time.
START TIME
HH:MM DD MM
4. The sampler will advance the hour to the next hour after
the present time. The day and month will be the current
day and month. You can accept this time by pressing the
Enter key or enter the start time you choose. After a valid
time has been entered, the sampler will start. See Section
2.6, Active State Displays.
5. If you enter a time that has passed, the MUST BE LATER
THAN screen appears. Enter a valid start time. The sam-
2-12