Basic Analysis and Graphing - SAS

Chapter 5 Performing Oneway Analysis 131
The Oneway Plot
Launch the Oneway Platform
You can perform a Oneway analysis using either the Fit Y by X platform or the Oneway platform. The two
approaches are equivalent.
• To launch the Fit Y by X platform, select Analyze > Fit Y by X.
or
• To launch the Oneway platform, from the JMP Starter window, click on the Basic category and click
Oneway.
Figure 5.4 The Oneway Launch Window
For more information about this launch window, see “Introduction to the Fit Y by X Platform” chapter on
page 87.
The Oneway Plot
The Oneway plot shows the response points for each X factor value. You can compare the distribution of the
response across the levels of the X factor. The distinct values of X are sometimes called levels.
Replace variables in the plot in one of two ways: swap existing variables by dragging and dropping a variable
from one axis to the other axis; or, click on a variable in the Columns panel of the associated data table and
drag it onto an axis.
You can add reports, additional plots, and tests to the report window using the options in the red triangle
menu for Oneway Analysis. See “Oneway Platform Options” on page 132.
To produce the plot shown in Figure 5.5, follow the instructions in “Example of Oneway Analysis” on
page 129.