Basic Analysis and Graphing - SAS

94 Performing Bivariate Analysis Chapter 4
The Bivariate Plot
Figure 4.3 The Bivariate Launch Window
For information about this launch window, see “Introduction to the Fit Y by X Platform” chapter on
page 87.
The Bivariate Plot
To produce the plot shown in Figure 4.4, follow the instructions in “Example of Bivariate Analysis” on
page 93.
Figure 4.4 The Bivariate Plot
The Bivariate report begins with a plot for each pair of X and Y variables. Replace variables in the plot by
dragging and dropping a variable, in one of two ways: swap existing variables by dragging and dropping a
variable from one axis to the other axis; or, click on a variable in the Columns panel of the associated data
table and drag it onto an axis.