download - Knoll

Electrical Infeeds and Power Poles
Specifications
Dividends Horizon
Power Infeeds
base raceway. Two styles are available:
Base Power Infeed
Dividends Horizon base power infeeds route
power from floor monuments or electrical boxes
to any terminal block duplex position on base
raceway power modules. Two screws secure
the base power infeed to the power module.
Note: When connected, a base power infeed
takes the place of one duplex outlet.
Base power infeeds have a 56" long liquid
tight conduit and pigtail for connection
Infeeds are specified either right- or left-handed.
This allows the conduit to enter the outlet
position from either the left or right side.
In addition to right- or left handed base
power infeeds is a reversible base power
infeed with a 56" long liquid tight conduit.
The reversible infeed rotates to provide
either a right- or left-hand power entry.
Specify the base infeed that matches the
power system accessed and left or right
cable entry (example: (3+1), left-hand entry).
Ceiling Infeeds
Raceway-to-ceiling infeeds route power from
a ceiling-located power source to the panel
which plug into any terminal block outlet
position, ceiling infeeds must plug into the end of
a base raceway power module. Ceiling infeeds
have a 19 1 / 2' long metal conduit and pigtail.
Two components are required for installation:
Ceiling infeed may be installed directly into a
beltway power module for beltway electrical only.
Specify the ceiling infeed that matches
the power system accessed.
Power Poles
Power poles can accommodate one racewayto-ceiling
infeed along with data cables. The
power pole can also be used to route data
cables only, if required. Cable capacity for
power poles with the electrical conduit installed
is 30, category 5 cables and without an
electrical conduit is 40, category 5 cables.
Power poles integrate within the panel system
footprint by mounting atop existing post
Power poles are available in three lengths in
order to accommodate all three heights of
post connectors. All power poles measure
126" or 144" when added to the height of
the post connector. For ceilings less than
126" or 144" high, field-cut the power pole
to the required height. Power poles include
ceiling trim plate, connecting hardware
and post/power pole trim covers.
Legacy Power Pole Construction
Power pole is extruded aluminum powder
coated, with four PVC trim covers.
Dividends Horizon DP7 Power Pole
Construction
Power pole is extruded aluminum, with
removable cover, powder coated in any
Knoll Core or Dividends Horizon Legacy
finish. One side of the power pole is
open, allowing cables to be inserted or
removed when the cover is removed.
CAUTION: DO NOT CONNECT POWER
UNTIL INSTALLATION IS COMPLETE.
CONNECTION TO BUILDING POWER
SOURCE MUST BE PERFORMED
BY A LICENSED ELECTRICIAN.
Ceiling Connection
Ceiling Infeed Connection
Ceiling
Connection
Ceiling Infeed,
Ceiling Connection
Power Pole
Power Infeeds
Power Pole
Connection
Base Power Infeed
(right infeed shown)
Ceiling Infeed
Base Raceway
Connection
Ceiling Infeed
Base Raceway
Connection
Base Raceway
Infeed Connection
(right infeed shown)
Reversible Base
Power Infeed
198