download - Knoll

Worksurface Specifications
Worksurface Options
Dividends Horizon
Available Worksurface Styles
• Rectangular
• Rectilinear corner
• Split top corner
• Curvilinear corner
• Trapezoid
• Smooth wave
• Curvilinear wave end
• Half-round
• Quarter-round
• Blended ‘‘D’’ shape
• ‘‘D’’ shape peninsula
• ‘‘P’’ and ‘‘9’’ shape peninsula
• Counter Worksurfaces
• Transition
Universal Applications
The undersides of worksurfaces are predrilled
to accept various panel-hung and
freestanding supports. Cascade edge
worksurfaces do not have pre-drilled holes.
All supports must be ordered separately.
In panel-hung applications,
worksurfaces are supported by:
• Cantilevers
• Pedestals
• Panel-to-worksurface brackets
• Flat brackets
• Panel-mounted C-leg support
• Open support legs
In peninsula applications, worksurfaces
are supported by panels on one end
and the other end is supported by:
• Support column
• A leg
• T support base
For freestanding applications,
worksurface support is provided by:
• Pedestals
• End units
• Flat brackets
Construction
Laminate
• Surface material: .028 high-pressure
laminate on top surface with a
paper backer on under side
• Edge material: 2mm ABS on
straight and curved surfaces
• Core material: 45 lb. density particle board
• Thickness: 1 1 / 4"
Techwood
• Surface material: 0.6mm veneer
• Edge material: 0.6mm veneer on
straight and curved surfaces
• Core material: 45 lb. density particle board
• Thickness: 1 1/4"
For available sizes, refer to the individual
worksurface categories within this section.
Optional Edge Grommets
Edge grommets are optional and can be
specified factory-installed centered along the
rear edge of rectangular, rectilinear corner,
curvilinear wave end, and curvilinear corner
worksurfaces. Grommets can also be retrofitted
to worksurfaces by ordering an edge grommet
kit (pattern number D1WSG). The edge grommet
kit allows grommets to be field-installed in any
location along the rear edge of worksurfaces.
Note: Edge grommets on 'D', '9', and 'P'
peninsula worksurfaces are located on the
panel hung side.
Cable Management
A 1 / 2" reveal is provided between the
worksurface and panel for cable management.
When edge grommets are specified, the
grommet works in conjunction with the 1 / 2"
reveal to allow plugs to be inserted through the
grommet and cables to be positioned anywhere
along the rear edge of the worksurface.
Loading Capacities
Maximum weight allowed for worksurfaces:
• 24"-42" wide: 200 lbs.
• 48" wide: 216 lbs.
• 54" wide: 243 lbs.
• 60" wide: 270 lbs.
• 66" wide: 297 lbs.
• 72" wide: 324 lbs.
• 78" wide: 351 lbs.
• 84" wide: 378 lbs.
• 90" wide: 405 lbs:
• 96" wide: 432 lbs.
Note: Installations which violate these
requirements will not be covered
by the Knoll, Inc. warranty.
Worksurfaces and Supports,
Panel Application
Worksurfaces and Supports,
Freestanding Application
2mm ABS Edge Detail
Optional
Grommet
1
/ 2" Cable
Management Reveal
Worksurface Cable Management
290