download - Knoll

Desk Accessories
Planning Guidelines
Dividends Horizon
Pencil Tray
Five section tray rides on drawer sides
of box drawers. Plastic injection molded
construction. 13 1 / 4 wide, 5 7 / 16 deep and
7
/ 8 high. Black or clear finish available.
Hanging File Bar
Allows for side-to-side hanging folders. 20-gauge
steel construction. Set of two. Black finish.
Note: A hanging file bar is included with each
file drawer when ordering desks or pedestals.
Drawer Dividers
Two styles available: box drawer and file drawer
sizes. 18-gauge steel construction. Black finish.
Stationery Inserts
Set of four trays for use in box drawers. 18-
gauge steel construction. Can accommodate
letter-and legal-sized stationery. Black finish.
Pencil Drawer
For use with freestanding desks or panelmounted
worksurfaces with depths of 24
or more. 24 wide, 17 5 / 8 deep and 2 high.
Black finish.
Attachment: Mounts on underside of
worksurface with included mounting hardware
Pedestal Lock Retrofit Kit
Allows existing nonlocking pedestals to be
field-retrofitted with locks. Includes lock
housing, lock core (keyed randomly unless
specified keyed alike) and lock rod assembly
(must be specified box/box/file or file/file).
Flat Brackets
Allow same-height worksurfaces to be
joined in perpendicular configurations. All
flat brackets are 3 3 / 4 wide. Black finish.
Three sizes available to support the
following worksurface depths:
of worksurfaces in pre-drilled locations
with included mounting hardware
Worksurface Cable Management Clips
Self-adhesive, injection-molded clips
adhere to any flat, nonporous surface
to route cables along and beneath
worksurfaces. 3 / 4 x 1 / 2 internal dimension.
Worksurface Cable Management Basket
Steel wire basket attaches to the underside
of worksurfaces to provide management of
excess cords and cables. Once installed,
the cable basket slides forward to a position
abutting the panel face to allow the passage
of cords and cables. Black finish.
Worksurface Edge Grommet
Available factory-installed when ordering
worksurfaces or as a kit for field installation.
Can be installed in any location along the
rear edge of worksurfaces. Includes a cutting
template, grommet and cover. Dark grey finish.
Worksurface Reinforcement
Worksurface reinforcements are required for
worksurface spans greater than 48 inches. This
includes freestanding desk worksurfaces over
48 inches using desk end units. Worksurface
reinforcements have a black paint finish.
Pencil Tray
Pencil Drawer
Stationery Inserts
Worksurface Cable
Management Clip
Hanging File Bar
Drawer Divider,
File Drawer
Flat Bracket
Worksurface Cable
Management Basket
Drawer Divider,
Box Drawer
Worksurface Reinforcement
Panel Hung Application
Worksurface
Edge Grommet
370