download - Knoll

Curvilinear Half- and Corner-Round Worksurfaces
Specifications
Dividends Horizon
Curvilinear Half-Round Worksurfaces
Curvilinear half-round worksurfaces are
sized to match up to the width of two
back-to-back 24" deep or two back-toback
30" deep freestanding desks.
Panel-supported half-round worksurfaces
are notched along the flat end to
accommodate the panel end trim.
Attachment is with a column support, T leg or
A leg (must be ordered separately) at the free
end of the worksurface and with flat brackets
on the flat end of the half-round worksurface.
The flat brackets attach to the adjacent
freestanding desks. Flat brackets are black.
Available Sizes
1 / 4
Note: All Dividends Horizon worksurfaces
include a 1 / 2" wire drop at the rear edge.
When used back to back with Half-Round
worksurface, these two 1 / 2" wire drops will meet
to form a 1" space between worksurfaces.
Transition Worksurfaces
Attachment is with a column support, T leg or
A leg (must be ordered separately) at the free
end of the worksurface and with flat brackets
on the flat end of the transition worksurface.
The flat brackets attach to the adjacent
freestanding desks. Flat brackets are black.
Available Sizes
1 / 4
Corner Round Worksurfaces
Corner-round worksurfaces are designed to
‘‘finish’’ a run of panel-mounted worksurfaces.
Corner-round may be specified in two ways.
In a 90° ‘‘L’’ configuration, a notched
corner-round worksurface is used to wrap
around the panels. Two cantilevers and
flat brackets (must be ordered separately)
support the corner-round worksurface.
In an end run configuration, the corner-round
worksurface is handed and must be specified
as a left-hand or a right-hand top. One
cantilever with a flat bracket and one panelto-worksurface
bracket (must be ordered
separately) support the corner-round top.
Available Sizes
Optional Edge Grommets
Grommets are not available for worksurfaces
on this page.
Curvilinear Half-Round
Worksurfaces (without panels)
Curvilinear Half-Round
Worksurfaces (with panels)
Corner-Round Worksurface
Corner-Round Applications
Notched Corner Worksurfae
Corner-Round - Notched
“L” Configuration
Corner-Round - End Run
Configuration (right-hand shown)
Quarter-round Surface
312