download - Knoll

Corner Worksurfaces
Curvilinear Corner ‘‘L’’ Shape - 24 Depths
Specifications
Dividends Horizon
Curvilinear Corner L Shape Worksurfaces
Dividends Horizon curvilinear corner "L"
shape worksurfaces are specified for
panel-hung applications only and provide a
continuous flow when used in conjunction
with other curvilinear worksurfaces.
Curvilinear Corner Worksurface Support
Curvilinear corner "L" shape worksurfaces
must be supported by cantilevers at each end
and a panel-to-worksurface bracket at the
rear corner. Panel-mounted C-leg or open leg
worksurface supports may be used instead of
cantilevers for corner worksurface support.
Cantilevers, panel-mounted c-leg and open
support legs are ordered separately. A
panel-to-worksurface bracket is included.
Note: Worksurfaces greater than 48" wide
require an additional mid-span cantilever
support along the 60" or 72" side.
Note: A pedestal, panel-mounted C-leg or
Open Leg Support can be substituted for
a cantilever in the following locations:
curvilinear "L" shape corner worksurfaces
Note: Series 3 overdesk units are not
compatible with corner worksurfaces.
Curvilinear Corner Worksurface
Curvilinear Corner Worksurface
Support Options
Curvilinear Corner Worksurface
Applications
3' 3'
3'
3'
Curvilinear Corner “L”
Shape Worksurface
4'
2'
4'
**
2'
** Requires a return panel or
pedestal/panel-mounted C-leg or
Open Support Leg with panel-toworksurface
bracket for support
306