11.06.2014 Views

TAGnology_TAGid -125kHz_Protocol.pdf - RFID Webshop

TAGnology_TAGid -125kHz_Protocol.pdf - RFID Webshop

TAGnology_TAGid -125kHz_Protocol.pdf - RFID Webshop

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

February 1999 Rev. 1.2 Communication Reader-Host<br />

3.7.28 RWD_Reset_Sys<br />

This command resets basic functions of the read/write device. All port-pins of the HITAG<br />

Communication Controller are reset to an initial state (output pins are set to ‘0’, input pins are<br />

set to ‘1’).<br />

You should not interrupt the Permanent Reading Mode (activated after ReadMiro, ReadPit, ...)<br />

or the permanent writing mode (e.g. activated after WritePit) of the read/write device by<br />

invoking this command, since Reset can cause undesirable side effects (resetting output pins).<br />

Use StopCommand instead.<br />

C-Function: void RWD_Reset_Sys (void);<br />

Header-File: HitagRWD.H<br />

Serial protocol:<br />

HOST - READ/WRITE DEVICE<br />

0x02 'R' 0x50<br />

READ/WRITE DEVICE - HOST<br />

0x02 Status BCC<br />

Status: 0 ... no error<br />

-1 ... SERIAL ERROR<br />

Page 45 (107)<br />

Protokoll HTRM801 V1.2/C

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!