TAGnology_TAGid -125kHz_Protocol.pdf - RFID Webshop

More documents

Recommendations

Info

Communication Reader-Host Rev. 1.2 February 1999 3.7.40 RWD_Set_HF_Mode This command sets the read/write device into Proximity or Long Range Mode. In standard applications (e.g. using standard reader hardware from Philips) RWD_Set_HF_Mode is not used because the HITAG Communication Controller automatically sets the right mode after power-up. Examples: • SetHFMode setting the mode to Long Range sets a Proximity Reader in a powerdown-state with reduced power consumption. • SetHFMode can be used in a system with a Proximity RF-part and a Long Range RF-part to select one part at a time. C-Function: void RWD_Set_HF_Mode (BYTE_T mode); Header-File: HitagRWD.H Serial protocol: HOST - READ/WRITE DEVICE 0x03 'L' mode BCC mode: 0x00 ... Proximity Mode 0x01 ... Long Range Mode READ/WRITE DEVICE - HOST 0x02 Status BCC Status: 0 ... no error -1 ... SERIAL ERROR Protokoll HTRM801 V1.2/C Page 56 (107)
February 1999 Rev. 1.2 Communication Reader-Host 3.7.41 RWD_FFT_Command This Long Range Reader command starts the FFT (Fast Fourier Transformation) of the DSP (Digital Signal Processor) with the current BitClockDelay (BCD) value in the EEPROM of the read/write device. This function suppresses up to two harmonic electromagnetic disturbers in the RF Band of the receiver (105 kHz - 145 kHz), e.g. from computers or monitors. Use this function as often as new RF background noise arises near the Long Range antenna. ATTENTION: As the answer to this command appears before the FFT is ready (duration of FFT is approximately 110 ms), the host program has to wait at least 50 ms until sending the next transponder command. C-Function: void RWD_FFT_Command (void); Header-File: HitagRWD.H Serial protocol: HOST - READ/WRITE DEVICE 0x02 'F' 0x44 READ/WRITE DEVICE - HOST 0x02 Status BCC Status: 0 ... no error -1 ... SERIAL ERROR -8 ... ACKNOWLEDGEMENT ERROR The DSP did not send a correct acknowledge. The error leads to a reset of the read/write device. Page 57 (107) Protokoll HTRM801 V1.2/C
Page 1 and 2:
TAGnology RFID GmbH | Grazer Vorsta
Page 3 and 4:
February 1999 Rev. 1.2 Introduction
Page 5 and 6: February 1999 Rev. 1.2 Introduction
Page 7 and 8: February 1999 Rev. 1.2 Introduction
Page 9 and 10: February 1999 Rev. 1.2 Provided Hos
Page 11 and 12: February 1999 Rev. 1.2 Communicatio
Page 55: February 1999 Rev. 1.2 Communicatio
Page 85 and 86: February 1999 Rev. 1.2 Transponders
Page 95 and 96: February 1999 Rev. 1.2 Personalizat
Page 105 and 106: February 1999 Rev. 1.2 Security Con
Page 107:
February 1999 Rev. 1.2 Security Con
show all

TAGnology_TAGid -125kHz_Protocol.pdf - RFID Webshop

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?