11.06.2014 Views

TAGnology_TAGid -125kHz_Protocol.pdf - RFID Webshop

TAGnology_TAGid -125kHz_Protocol.pdf - RFID Webshop

TAGnology_TAGid -125kHz_Protocol.pdf - RFID Webshop

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

February 1999 Rev. 1.2 Communication Reader-Host<br />

3.7.43 RWD_Set_BCD<br />

This Long Range Reader command effects that a new BCD (BitClockDelay) value is passed to<br />

the DSP (Digital Signal Processor) and written into the EEPROM of the read/write device. This<br />

value adjusts the timing of the read/write device in accordance to the connected antenna.<br />

A new adjustment may be necessary whenever a new type of antenna is connected to the<br />

read/write device.<br />

Bits 4-7 of -bitclockdata- represent the BCD value. If Bit 3 of -bitclockdata- is set to 0, a FFT<br />

(Fast Fourier Transformation) of the DSP with the new BCD value is started in addition.<br />

Standard value stored in the EEPROM:<br />

bitclockdata = 0x90<br />

C-Function: void RWD_Set_BCD (BYTE_T bitclockdata);<br />

Header-File: HitagRWD.H<br />

Serial protocol:<br />

HOST - READ/WRITE DEVICE<br />

0x03 'F' Bitclockdata BCC<br />

bitclockdata:<br />

7 6 5 4 3 2 1 0<br />

bitclockdelay bitclockdelay bitclockdelay bitclockdelay mode 0 0 0<br />

Bit 3 Bit 2 Bit 1 Bit 0<br />

bitclockdelay: 0 ... 15 dec possible<br />

mode: 0 ... start a FFT<br />

1 ... no FFT<br />

READ/WRITE DEVICE - HOST<br />

0x02 Status BCC<br />

Status:<br />

0 ... no error<br />

-1 ... SERIAL ERROR<br />

-8 ... ACKNOWLEDGEMENT ERROR<br />

The DSP did not send a correct acknowledge.<br />

The error leads to a reset of the read/write device.<br />

Page 59 (107)<br />

Protokoll HTRM801 V1.2/C

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!