technical manual for sailor compact hf ssb t2130 - Gopher Proxy

More documents

Recommendations

Info

2 INSTALLATION MECHANICAL HF SSB TRANSMITTER T2130 1 HOUR REQUIREMENT: The radio batteries must have sufficient capacity to supply the radio station for 1 hour (0.5 hours transmit and 0.5 hours standby). When the battery is drained in 1 hour, instead of the 24 hours, you have add 50% to the capacity given be the manufacture. The half hour transmit has to be in telex mode ARQ. Equipment Mode Current Battery capacity T2130/DSC transmit 15A 7.5Ah T2130/DSC standby 1A 0.5Ah VHF/DSC transmit 7A 3.5Ah VHF/DSC standby .33A .17Ah EMERGENCY LIGHT on 1A 1Ah GPS RECEIVER on 1A 1Ah TOTAL 1 HOURS 13.7Ah +50% 20.6Ah If you chose to make a installation without AC power supply N2161. Then you must have a battery charger large enough to ensure, that you not will drain your batteries during transmission. That gives a charger requirement of 25 amp. The maximum allowable charge current is 10% of the battery capacity. When the charger can give 25 amps the battery capacity must be 250Ah. We recommend 250Ah battery capacity. If you chose to make a installation with AC and DC power supply N2161. Then you must have a battery charger large enough to ensure, that you can charge your batteries within 10 hours. That gives a charger requirement of 3 amp. The maximum allowable charge current is 10% of the battery capacity. We recommend 60Ah battery capacity. PAGE 2-6 9315
2 INSTALLATION MECHANICAL HF SSB TRANSMITTER T2130 2.2.3 AERIAL AND RF GROUNDING REQUIREMENTS AERIAL Most important for good communication is the aerial. The best efficiency of the aerial will be with the aerial coupler AT2110 mounted outdoors close to the footpoint of the aerial and the aerial placed as high and free as possible. The aerial coupler AT2110 has to be grounded carefully. AERIAL LENGTH Max. length 15 metres, min. length 7 metres. Aerial length measured from insulator on AT2110 to the top of the aerial. If the transmitter has to work mainly on frequencies below 4 MHz a total aerial length of 12-14 metres is recommended. If the transmitter has to work mainly on frequencies higher than 4 MHz an 8.5 m whip aerial is recommended. GROUND AT2110 has to be grounded at the footpoint of the aerial. If a metal wheel house, weld up a pillar for AT2110 and bolt it to the pillar. This is the best way of getting a good ground for the aerial system. If a wooden or fibre glass boat, connect all accessible metal parts together and connect them to the aerial coupler with a copper strip (100 x 0.5 m) making the copper strip as short as possible. You can also make an artificial ground under the aerial as shown in example 5. Example 1. AT2110 mounted on top of a wheel house with a whip aerial. AT2110 has to be grounded through the two lower mounting holes. PAGE 2-7
Page 1: TECHNICAL MANUAL FOR SAILOR COMPACT
Page 5 and 6: T2130 CONTENTS 1 GENERAL INFORMATIO
Page 7: T2130 CONTENTS 1 GENERAL INFORMATIO
Page 10 and 11: 1 GENERAL INFORMATION T2130 1.3 TEC
Page 12 and 13: 1 GENERAL INFORMATION T2130 1.4 PRI
Page 15: T2130 CONTENTS 2 INSTALLATION MECHA
Page 18 and 19: 2 INSTALLATION MECHANICAL HF SSB TR
Page 54 and 55: T2130 3.7.1 MODULES REPLACED 3-23 3
Page 56 and 57: 3 SERVICE T2130 3.4 TROUBLE SHOOTIN
Page 58 and 59: 3 SERVICE T2130 If the error has ap
Page 60 and 61: 3 SERVICE T2130 3.4.2 OUTPUT FILTER
Page 62 and 63: 3 SERVICE T2130 3.4.4 POWER SUPPLY
Page 64 and 65: 3 SERVICE T2130 3.4.5 NOT USED 3.4.
Page 66 and 67: 3 SERVICE T2130 3.5.1 POWER AMPLIFI
Page 68 and 69: 3 SERVICE T2130 3.5.3 TX-PROCESSOR
Page 70 and 71: 3 SERVICE T2130 3.5.3.3 RF ON/OFF T
Page 72 and 73:
3 SERVICE T2130 3.5.3.9 TUNE MOTOR
Page 74 and 75:
3 SERVICE T2130 3.5.5 NOT USED 3.5.
Page 76 and 77:
3 SERVICE T2130 IMPORTANT! the inpu
Page 78 and 79:
3 SERVICE T2130 3.7.2 COMPONENTS RE
Page 80 and 81:
3 SERVICE T2130 3.8.12 OUTPUT POWER
Page 82 and 83:
3 SERVICE T2130 SP-22-0 Displays th
Page 84 and 85:
3 SERVICE T2130 Operator: Key: 25 R
Page 86 and 87:
3 SERVICE T2130 SP-33 Adjustment of
Page 89:
T2130 CONTENTS 4 MECHANICAL DISASSE
Page 93 and 94:
4 MECHANICAL DISASSEMBLING T2130 4.
Page 95:
T2130 CONTENTS 5 CIRCUIT DESCRIPTIO
Page 98 and 99:
5 CIRCUIT DESCRIPTION AND SCHEMATIC
Page 100 and 101:
Page 102 and 103:
T2130 5 CIRCUIT DESCRIPTION AND SCH
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 131 and 132:
T2130 6 PARTS LIST HF SSB T2130 MF/
Page 133 and 134:
6 PARTSLIST T2130 POSITION DESCRIPT
Page 135 and 136:
Page 137 and 138:
show all

technical manual for sailor compact hf ssb t2130 - Gopher Proxy

Create successful ePaper yourself

Delete template?

Save as template?