technical manual for sailor compact hf ssb t2130 - Gopher Proxy
technical manual for sailor compact hf ssb t2130 - Gopher Proxy
technical manual for sailor compact hf ssb t2130 - Gopher Proxy
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3 SERVICE T2130<br />
3.4.1 POWER AMPLIFIER (MODULE 1)<br />
Connect a 50 ohm load to RF in/out (ST04) on the Connection Board (6).<br />
3.4.1.1 ERROR 71. VFORWARD LOW<br />
This means that there is no output from the PA-module.<br />
Select service programme SP-29, see section 3.9.1.<br />
3.4.1.2<br />
Check the RF-input level on the PA-module (1).<br />
Approx. 1.2 Vpp.<br />
3.4.1.3<br />
Check the RF-output level on the PA-module (1).<br />
Approx. 200 Vpp.<br />
3.4.1.4<br />
Check of bias. Note only when the output is zero. See chapter 3.6. ADJUSTMENT PROCEDURE,<br />
sections 3.6.1.1 to 3.6.1.4.<br />
3.4.1.5<br />
If the measurement above is ok, then the fault is probably to be found in the Output Filter (2).<br />
3.4.1.6 ERROR 74. TRANSMITTER TEMPERATURE HIGH<br />
The temperature on the output transistors is too high.<br />
3.4.1.7<br />
Check that there are free air circulation around the transmitter and the ambient temperature is not more<br />
than 40°C. If the temperature is higher the per<strong>for</strong>mance will be reduced.<br />
3.4.1.8<br />
Check R45 (temperature sensor) located on one of the screws holding Q10 (see component location <strong>for</strong><br />
Power Amplifier (1) in chapter 5.1). When it is 25°C the resistance is 2.00 Kohm.<br />
3.4.1.9<br />
Check if the output transistors have a good thermal contact to the heatsink.<br />
IMPORTANT! Always use thermal compound <strong>for</strong> the power transistors. (e.g. Wakefield part No.<br />
120-8 or equivalent).<br />
PAGE 3-5