Command Reference - Stollmann

TA+USBA Command Reference 1.01/06.2007
2. Using the TA+USB
12 Local flow control (Read only)
Handles and displays used flow control on asynchronous line.
0: no flow control
3: flow control RTS / CTS
4: flow control XON / XOFF
Extended Parameters 13 through 24
14 Line Feed Fill Characters
Defines, whether fill characters should be sent following a line feed .
Valid Parameter Values:
0 No fill characters after a
n Following a on the screen, append n fill characters . n is
an integer in the range from 1 to 255.
15 Control Input Buffer Editing
Defines, whether characters in the input buffer may be edited.
Valid Parameter Values:
0 No editing; the values of the parameters 16, 17, 18, and 19 will be
ignored.
1 Editing enabled and the editing features set by the parameters 16, 17,
18, and 19 may be used; in this case, it is not possible to do a
preemptive transmission of a data packet using the Data Forwarding
Character (see parameter 4).
16 Delete Character
Defines the Character-Delete character, thus the ASCII value of the character that
when entered will delete the previously entered character. Only possible, when
parameter 15 is set to 1 (PAD has editor capability).
Valid Parameter Values:
n n is an integer in the range from 1 to 255 and gives the ASCII value
(decimal) of the desired Character-Delete character.
default = 8 (=> < BACKSPACE> key)
10 © Stollmann Entwicklungs- und Vertriebs-GmbH