PDF | 8 MB - Australian Building Codes Board

More documents

Recommendations

Info

Page 18 Australian Building Codes Board Deemed-to-Satisfy Provisions G P/H Orientation Sector (refer Figure J2.3) (refer Figure (refer Figure North North East South South South West North J2.4) J2.4) east east west west 0.0 1.00 1.00 1.00 1.00 1.00 1.00 1.00 1.00 0.2 0.97 0.98 0.98 0.98 0.97 0.98 0.98 0.97 0.4 0.88 0.93 0.94 0.93 0.93 0.93 0.93 0.92 0.6 0.78 0.84 0.87 0.86 0.87 0.86 0.87 0.83 More than 0.8 0.66 0.74 0.79 0.79 0.81 0.80 0.80 0.74 500 mm but not more than 1.0 0.56 0.64 0.71 0.72 0.75 0.73 0.73 0.64 1200 mm 1.2 0.49 0.56 0.65 0.66 0.71 0.68 0.66 0.57 1.4 0.46 0.50 0.59 0.61 0.68 0.64 0.61 0.51 1.6 0.44 0.45 0.54 0.57 0.66 0.60 0.56 0.47 1.8 0.43 0.42 0.49 0.54 0.63 0.57 0.52 0.44 2.0 0.42 0.40 0.46 0.52 0.61 0.53 0.49 0.42 0.0 1.00 1.00 1.00 1.00 1.00 1.00 1.00 1.00 0.2 0.98 0.99 0.99 0.99 0.99 0.99 0.99 0.99 0.4 0.93 0.96 0.96 0.96 0.95 0.96 0.96 0.95 0.6 0.86 0.91 0.93 0.91 0.91 0.91 0.92 0.90 More than 0.8 0.78 0.84 0.87 0.86 0.87 0.86 0.87 0.83 1200 mm but less than 1.0 0.69 0.77 0.82 0.80 0.82 0.81 0.81 0.76 1800 mm 1.2 0.60 0.69 0.75 0.75 0.78 0.76 0.76 0.68 Notes: 1.4 0.54 0.62 0.69 0.70 0.74 0.72 0.70 0.62 1.6 0.49 0.55 0.65 0.65 0.71 0.68 0.66 0.56 1.8 0.47 0.50 0.60 0.62 0.69 0.64 0.61 0.52 2.0 0.45 0.46 0.55 0.58 0.67 0.61 0.57 0.48 1. Where G is 1800 mm or more, the cooling shading multiplier is to be taken as 1.0. 2. The cooling shading multiplier for P/H values between those shown in Table J2.4d can be interpolated. 3. For glazing in the internal fabric use the appropriate value for the south orientation sector with a P/H value of 2.0. PUBLIC COMMENT DRAFT Table J2.4e SHADING MULTIPLIERS FOR GLAZING IN THE INTERNAL FABRIC Climate zone Shading multiplier Heating (S H ) Cooling (S C ) 1, 2 and 3 1.0 0.49 4 and 5 0.64 0.54 J2.4 NCC2014 Volume One
Australian Building Codes Board Page 19 Deemed-to-Satisfy Provisions 6 and 7 0.55 0.55 8 0.51 0.53 Figure J2.3 ORIENTATION SECTORS Note: The orientation sector for a wall or glazing element is the sector that contains a line drawn perpendicular to the face of the wall or glazing element. PUBLIC COMMENT DRAFT NCC2014 Volume One J2.4
Page 1 and 2:
Page 2 Australian Building Codes Bo
Page 3 and 4:
Australian Building Codes Board Pag
Page 5 and 6:
Page 18 Australian Building Codes B
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 2 (ii) (iii) area of the build
Page 17 and 18:
(b) (c) Australian Building Codes B
Page 19 and 20:
Page 4 (iv) Australian Building Cod
Page 21 and 22:
(b) (ii) Australian Building Codes
Page 23 and 24:
E1.4 Fire hose reels (a) (b) (c) (d
Page 25 and 26:
Page 27 and 28:
Page 10 Australian Building Codes B
Page 29 and 30:
(b) Australian Building Codes Board
Page 31 and 32:
Page 33 and 34: Page 2 Australian Building Codes Bo
Page 35 and 36: Australian Building Codes Board Pag
Page 39 and 40: Page 16 Australian Building Codes B
Page 67 and 68: Safety measure Australian Building
Page 77 and 78: (e) (f) (g) (iii) (Y) (Z) Australia
Page 81 and 82: Table J2.4a ENERGY INDEX Applicatio
Page 83: Page 10 Australian Building Codes B
Page 97 and 98: Reference Section B B1.4(i)(ii)(C)
Page 99: Reference FV5.3 Australian Building
show all

PDF | 8 MB - Australian Building Codes Board

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?