Operation

Menzi Muck A61
6 Controls
6.1 Main switch
The main switch (A) is located at the rear to the right of
the engine support. If the machine is not to be used for
a prolonged period, switch it off so that the batteries are
disconnected from all consumersThe diagram shows the
main switch in the OFF position. To switch it on, it has to
be turned 90° clockwise.If the machine is not to be used
for a prolonged period, switch it off so that the batteries are
disconnected from all consumers.
6.2 Emergency shut down switch
The Emergency shut down switch (4) shuts the machine down immediately
in an emergency situation. The Emergency shut down switch must be reset
before the machine can be restarted. Do this by turning it clockwise.
Before resetting the Emergency shut down switch, ensure that
restarting the machine will not pose any risk.
6.3 Ignition lock
The diagram shows the ignition lock (1) in the idle marked position. Turning
the ignition key clockwise to the first setting switches on the ignition. The engine oil pressure and
battery voltage indicators should light up at this point. If they do not, the cause of this failure MUST be
eliminated before the engine is started.
The next setting is the glow plug preheat position, when the machine is cold. The engine is started by
turning and holding the ignition lock in position 2. This function can be controlled on the display. If the
engine does not start after 30 seconds, turn the lock back to zero. ZKeep the ignition key turned until the
diesel engine starts. Release the key immediately and leave in this position. When you want to switch the
engine off, return the ignition key to its original position.
Wenn der Motor abgestellt werden soll, den Zündschlüssel in Ausgangsposition zurückdrehen.
The engine cannot be started if the ignition key was originally turned to the glow plug preheat
position and then allowed to return to the ignition position. Switch off the ignition and turn the
key again to the engine start position.
Seite – Betriebsanleitung