Maintenance and Care
Maintenance and Care
Maintenance and Care
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Working with the machine<br />
Attention !<br />
A full load when the engine <strong>and</strong> hydraulic system are<br />
cold<br />
• Can result in damage to property.<br />
• Operate the engine without a load for 1 - 2 minutes after startup<br />
or at a maximum speed of 1200 rpm. Increase this period<br />
by 2 - 4 minutes if the engine is operated below freezing<br />
point. The engine <strong>and</strong> the hydraulic system are thereby heated<br />
up slightly, thereby reducing wear to the engine.<br />
Warning !<br />
Defective armrest switch<br />
• Can result in death or severe injuries.<br />
• Check the armrest switch on the left armrest by: pulling up<br />
the left armrest (1) - moving the right joystick (2) to the left<br />
<strong>and</strong> the right. These or any other operations must not cause<br />
anything to move.<br />
Shut off the Diesel engine<br />
Attention !<br />
Immediately shutting off the engine after a full load<br />
• Can result in damage to property.<br />
• Before shutting off the engine, which has been operated<br />
• under a workload, allow it to run for at least 2 minutes at<br />
1000 - 1200 rpm until hot engine parts cool down.<br />
After the engine rundown time:<br />
1. Set the speed potentiometer anticlockwise to the minimum engine speed.<br />
2. Turn the ignition key anticlockwise to Position 0 <strong>and</strong> then remove the ignition<br />
key.<br />
Page 100 www.menzimuck.com<br />
2<br />
2<br />
1<br />
1
Change language