Altivar 38 - variable speed drive - user's manual

Access to Menus
The number of menus which can be accessed depends on the position of the access locking switch.
Each menu is made up of a number of parameters.
1st
power-up
Subsequent
power-ups
Language: French, English, German, Spanish,
Italian
LnG
LANGUAGE
ESC
access:
Macro-config: variable torque (factory setting)
If an input/output has been reassigned,
CuS: Customised is displayed
CFG
MACRO-CONFIG
or
ENGLISH
Identification: display of the drive power and
voltage
Display: display of electrical values, operation or
fault
rEF
15 kW 380/460 V
SUP
1-DISPLAY
or
Adjust: configuration of parameters which
can be accessed while the motor is rotating
SEt
2-ADJUST
Drive: motor-drive configuration
drC
3-DRIVE
Control: configuration of drive control:
terminal strip, operator terminal, RS485
CtL
4-CONTROL
I/O: configuration of the I/O assignment
5-I/O
I-O
Faults: configuration of the behaviour of the
motor-drive in the event of a fault, and the
protection devices
Files: saving and restoring the configuration
or return to factory settings
Only accessible if the "application" or
"communication" card is installed
APP
8-APPLICATION
FLt
6-FAULT
FLS
7-FILES
SL
8-COMMUNICATION
CAUTION: If an access code has already been programmed, it may be impossible to modify some menus;
these may not even be visible. In this case, see the section entitled “FILES menu” explaining how to enter the
access code.
89