Altivar 38 - variable speed drive - user's manual
Altivar 38 - variable speed drive - user's manual
Altivar 38 - variable speed drive - user's manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Control Menu<br />
Code Description Adjustment range Factory setting<br />
bSP deadb./pedst no<br />
BNS: pedestal<br />
BLS: deadband<br />
Management of operation at low <strong>speed</strong>:<br />
no<br />
F : motor frequency<br />
HSP<br />
F : motor frequency<br />
HSP<br />
CrL<br />
CrH<br />
LSP<br />
0<br />
F : motor frequency<br />
HSP<br />
LSP<br />
0<br />
AI2 min Ref. - mA<br />
AI2 Max Ref. - mA<br />
100 %<br />
100 %<br />
No<br />
Reference<br />
Deadband<br />
(BLS)<br />
Reference<br />
LSP<br />
0<br />
0 to 20 mA<br />
4 to 20 mA<br />
100 %<br />
Pedestal<br />
(BNS)<br />
Reference<br />
4 mA<br />
20 mA<br />
Minimum and maximum values of the signal on input AI2.<br />
These two parameters are used to define the signal sent to AI2. There are several configuration<br />
possibilities, one of which is to configure the input for a 0-20 mA, 4-20 mA, 20-4 mA, etc signal.<br />
ENGLISH<br />
Frequency<br />
HSP<br />
LSP<br />
0<br />
CrL CrH 20<br />
AI 2<br />
(mA)<br />
AOL<br />
AOH<br />
Min. Val AO - mA<br />
Max. Val AO - mA<br />
Parameter<br />
Max.<br />
0 to 20 mA<br />
0 to 20 mA<br />
0 mA<br />
20 mA<br />
Minimum and maximum values of the signal on outputs AO and<br />
AO1 (1)<br />
These two parameters are used to define the output signal on<br />
AO and AO1. Eg: 0-20 mA, 4-20 mA, 20-4mA, etc<br />
0<br />
AOL AOH 20<br />
AO (mA)<br />
(1) The AO output is available if an I/O extension card has been installed.<br />
100
Change language