Altivar 38 - variable speed drive - user's manual

I/O Menu
This menu can be accessed when the switch is in position .
The assignments can only be modified in stop mode with the drive locked.
Code
Function
LI2 LI2 Assign.
See the summary table and description of the functions.
The inputs and outputs available in the menu depend on the I/O cards installed (if any) in the drive, as well as
the selections made previously in the control menu.
Summary table of the logic input assignments (exc. 2-wire / 3-wire option)
I/O extension option cards
2 logic inputs LI5-LI6
Drive without option
3 logic inputs LI2 to LI4
NO :Not assigned (Not assigned) X
RV :Reverse (Reverse) X
RP2:Switch ramp2 (Ramp switching) X
JOG (Jog operation) X
+SP: + Speed (+ speed) X
-SP: - Speed (- speed) X
PS2: 2 Preset Speeds (2 preset speeds) X
PS4 : 4 Preset Speeds (4 preset speeds) X
PS8 : 8 Preset Speeds (8 preset speeds) X
NST:Freewhl Stop (Freewheel stop) X
DCI:DC inject. (Injection stop) X
FST:Fast stop (Fast stop) X
CHP:Multi. Motor (Motor switching) X
FLO:Forced Local (Forced local mode) X
RST:Fault Reset (Fault reset) X
RFC:Auto/Manu (Reference switching) X
ATN:Auto Tuning (Auto-tuning) X
PAU:PI Auto/Man (PI Auto/Man) If one AI = PIF X
PR2:PI 2 Preset (2 preset PI references) If one AI = PIF X
PR4:PI 4 Preset (4 preset PI references) If one AI = PIF X
EDD:Ext flt. (external fault) X
FTK: Forc.Keyp. (Force to keypad) X
ENGLISH
CAUTION: If a logic input is assigned to "Freewheel stop" or "Fast stop", start-up can only be
performed by linking this input to the +24V, as these stop functions are active when the inputs are at
state 0.
102