User Manual

- 36 -
The location of the sensor on the map will be saved in the monitoring system. In order to
remove the sensor from the map drag it into the group «All elements».
Removal of maps
Pic. 2.13: Assigning sensor to location on a map
In order to remove map, go to tab «Modules» and click on «Change», press button
"Delete". After the removal of map, all the sensors assigned to this image would lose their
specific locations on the map.
2.8 Adding logic circuit
Monitoring system allows the administrator to create logic for the system: to set specific
actions for the executive device (relay) and for the "Notifications" to be taken when a
specific combination of logic conditions of system elements occurs.
Logic circuit is a set of the conditions defining an event, and a set of actions taken by
monitoring system on occurrence of event.
Condition: if sensor changes mode. For example, temperature sensor with name "Temp1"
changes its mode to "Alarm". If there are no other conditions, as soon as sensor "Temp1"
will change to mode "Alarm", an event will take place, defined by the given set of conditions.
Conditions are united in set of conditions inside of a logic circuit by means of logical
operations AND/OR.
Action is transition of specific executive device (relay) into the given condition or actualization
of the specific element from group "Notifications". Actions are united in a set of
actions by means of logical operation AND.
Monitoring system allows to specify conditions and to set actions. Created logic circuit
can be found in tab "Logic schemes" of system web-interface (Pic. 2.14).
User Manual