DOC023.53.80040 sc200 Controller - Hachflow

More documents

Recommendations

Info

Figure 20 Feeder control function (Phase low, Overfeed timer) Option OnMax timer OffMax timer OnMin timer OffMin timer Description Sets the maximum time the relay can stay on independent from the measured value (default: + 0 min). Sets the maximum time the relay can stay off independent from the measured value (default: + 0 min). Sets the minimum time the relay can stay on independent from the measured value (default: + 0 min). Sets the minimum time the relay can stay off independent from the measured value (default: + 0 min). 1 Deadband 5 ON delay 2 Setpoint 6 OFF delay 3 Overfeed timer 7 Source (y-axis) 4 Time (x-axis) • Event Control Function (refer to Figure 21, Figure 22 and Figure 23) Option Set setpoint Deadband Description Sets the value where the relay will turn on. Sets a hysteresis so the relay will not swing unregulated when the process value converges to the setpoint. 32 English
Figure 21 Event control function (no delay) Figure 22 Event control function (OnMin timer, OffMin timer) 1 Source (y-axis) 5 Low alarm 2 High alarm 6 Time (x-axis) 3 Deadband 7 OnMax-time 4 Setpoint 8 OffMax-time 1 High alarm 5 Time (x-axis) 2 Deadband 6 OffMin timer 3 Setpoint 7 OnMin timer 4 Low alarm 8 Source (y-axis) English 33
Page 1: DOC023.53.80040 sc200 Controller 08
Page 4 and 5: Table of Contents Graphical display
Page 6 and 7: Table of Contents 4
Page 8 and 9: notice or obligation. Revised editi
Page 10 and 11: Relays outputs and signals The cont
Page 12 and 13: Figure 4 Panel mounting dimensions
Page 14 and 15: Figure 7 Wiring connections overvie
Page 16 and 17: 14 English
Page 18 and 19: The 24 VDC controller relays are de
Page 20 and 21: Analog output connections W A R N I
Page 22 and 23: Table 4 Input connections (continue
Page 24 and 25: Inputs and outputs are set up and c
Page 26 and 27: Option Description Advanced operati
Page 28 and 29: Outputs for analog output modules a
Page 30 and 31: Logarithmic output mode Figure 15 s
Page 32 and 33: • Alarm Function (refer to Figure
Page 36 and 37: Figure 23 Event control function (O
Page 38 and 39: Figure 25 Frequency control functio
Page 40 and 41: 6. Select a warning option and push
Page 42 and 43: 6. Allow time for the files to tran
Page 44 and 45: DataCom is used to upload software
Page 46 and 47: Problem Sensor not recognized Note:
Page 48: Description Item number Description

DOC023.53.80040 sc200 Controller - Hachflow

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?