DOC023.53.80040 sc200 Controller - Hachflow

Option
Description
Device scan information
Simulation (only
displays if sensors
or modules are
connected)
Modbus stats
System data
After the sim value is entered, the controller outputs
this value as if it was the value sent from the sensor.
The simulation stops after the user exits the screen.
Source-
•
•
(Footer displays current source selection)
Parameter—Source measurement type (footer
displays current source selection)
Sim value—Use arrow keys to change value (footer
displays current source selection)
Displays Error and Good count stats for selected port.
• Sensor port 1, 2, 3 or 4
• Network port
• Service port
• Clear stats
Warning and error conditions
Displays the current system current, temperature and
voltage data.
Follow the steps below to acknowledge controller warnings.
1. From the Settings menu, select Diagnostics and push ENTER.
2. Select the device (controller, sensor, network card) with the warning
or error and push ENTER.
3. Select the warning, error or event list and push ENTER.
4. Select Yes and push ENTER to acknowledge the warning.
Note: Errors cannot be acknowledged.
5. For more information on a specific warning, error or event, refer to
the device manual.
Display message
Installing device...please wait
Device missing
Action
Replacement parts and accessories
The controller has found a new device.
No action is necessary. The controller
automatically performs an installation
process for the new device and
displays the main measurement screen
of the device installed in the number
one position.
A previously installed device has been
removed from the controller or is not
detected.
• Push the Enter key to continue.
• Push the left arrow key to select or
de-select a missing device.
• Push the Enter key to delete the
missing device.
The controller will display the main
measurement screen for the device in
the number one position.
Note: This message also displays when a
device is missing and a new device has been
installed. After the missing device is deleted,
the controller automatically installs the new
device and displays Installing device...please
wait. The controller then displays the main
measurement screen for the device installed
in the number one position.
Note: Product and Article numbers may vary for some selling regions. Contact the
appropriate distributor or refer to the company website for contact information.
Description
Item number
4 GB Secure Digital Memory (SD) card 9218100
Connector kit for digital sensor 9201000
English 45