NAT-MCH Users Manual Version 1.16

NAT-MCH – Users Manual
9 Webserver
The NAT-MCH has an integrated embedded webserver which allows users to view and
change configuration parameters of the NAT-MCH.
Before the webserver can be used it has to be enabled via the MCH configuration (refer to
Chapter 5.4.1, “Web access”).
The onboard webserver can be accessed with any standard web browser by entering the IPaddress
of the management port of the NAT-MCH into the browser’s address line. After the
web browser has connected to the onboard webserver, the user is asked to enter a username
and the associated password. The default values for these are:
Username: root
Password: nat
The functions supported by the webserver may vary with new firmware releases. Currently
the following functions are supported.
Function
Setup Functions:
Sub Functions Description
Show MCH
- Shows the NAT-MCH Configuration similar to
Configuration
the command line interface command mch.
Change MCH
- Provides a graphical configuration menu to
Configuration
change the basic configuration of the NAT-MCH
similar to the command line interface command
mchcfg.
Port VLAN - Provides a graphical configuration menu to
change the port based VLAN settings. For more
details please refer to the Ethernet Switch
Configuration Manual.
802.1Q VLAN - Provides a graphical configuration menu to
change the 802.1Q VLAN settings. For more
details please refer to the Ethernet Switch
Configuration Manual.
802.1X - Provides a graphical configuration menu to
change the 802.1X protocol settings. For more
details please refer to the Ethernet Switch
Configuration Manual.
802.1P - Provides a graphical configuration menu to
change the 802.1P protocol settings. For more
details please refer to the Ethernet Switch
Configuration Manual.
Version 1.16 © N.A.T. GmbH 55