10.07.2015 Views

ORiNOCO® Access Points Installation and Management Guide ...

ORiNOCO® Access Points Installation and Management Guide ...

ORiNOCO® Access Points Installation and Management Guide ...

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Introduction1.4.2.2 TelnetYou can access the device through CLI by using Telnet. With Telnet, you can communicate with the device through your LAN(switch, hub <strong>and</strong> so on), Internet, or with an ethernet cable connected directly to your computer’s ethernet port.1.4.2.3 Secure Shell (SSH)You can securely access the device through CLI by using Secure Shell (SSH). The device supports SSH version 2, for secureremote CLI (Telnet) sessions. SSH provides strong authentication <strong>and</strong> encryption of session data. The SSH server has host keys- a pair of asymmetric keys (a private key that resides on the device) <strong>and</strong> a public key that is distributed to clients that need toconnect to the device. Clients need to verify that it is communicating with the correct SSH server.1.4.3 Simple Network <strong>Management</strong> Protocol (SNMP)v1/v2c/v3You can also configure, manage <strong>and</strong> monitor the device by using the Simple Network <strong>Management</strong> Protocol (SNMP). Thisrequires an SNMP Manager Program (sometimes called MIB browser) or a Network Manager program using SNMP. The devicesupports the following <strong>Management</strong> Information Base (MIB) files that describe the parameters that can be viewed <strong>and</strong>/orconfigured over SNMP:• PXM-SNMP.mib• RFC-1213.mib• RFC-1215.mib• RFC-2571.mib• RFC-2790.mib• RFC-3412.mib• RFC-3414.mib• IEEE 802.11mibThe Enterprise MIB defines the read <strong>and</strong> read-write objects that can be viewed or configured using SNMP. These objectscorrespond to most of the settings <strong>and</strong> statistics that are available with the other management interfaces. All Read-Only (RO)<strong>and</strong> Read-Write (RW) parameters supported by the IEEE802dot11-MIB are as tabulated below.S.No. MIB Object Name <strong>Access</strong>(RO / RW)1 dot11StationID RO2 dot11PrivacyOptionImplemented RO3 dot11Power<strong>Management</strong>Mode RO4 dot11DesiredSSID RW5 dot11DesiredBSSType RO6 dot11BeaconPeriod RW7 dot11DTIMPeriod RW8 dot11MultiDomainCapabilityImplemented RO9 dot11MultiDomainCapabilityEnabled RO10 dot11CountryString RO11 dot11AuthenticationAlgorithmsIndex RO12 dot11AuthenticationAlgorithm RO13 dot11AuthenticationAlgorithmsEnable RO14 dot11MACAddress RO15 dot11RTSThreshold RW<strong>ORiNOCO®</strong> AP-800 <strong>and</strong> AP-8000 <strong>Installation</strong> <strong>and</strong> <strong>Management</strong> <strong>Guide</strong> 14

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!