ORiNOCO® Access Points Installation and Management Guide ...

Device Configuration Using Web InterfaceRouge Scanning is done via two modes:a. Current Channel Scan: In this mode, the AP device scans all the wireless devices and Rouge APs in thecurrent operating channel, performing its normal AP functionality simultaneously. AP listens to all the datapackets transmitted over the current operating channel, interprets the beacons and probe responses from theneighboring devices and maintains its BSS throughput performance. It allows to scan a maximum of 32wireless devices in its vicinity. Once it exceeds the limit of 32 entries, it overwrites the oldest entry.b. All Channel Scan: In this mode, the AP device continuously scans all the available channels (both active andpassive depending on channel flags). It allows to scan a maximum of 512 wireless devices in its vicinity.By default, Rouge Scan Status is disabled. To enable and choose the preferred scan mode, select either CurrentChannel Scan or All channel Scan from the drop down menu.:• When Auto Channel Selection is enabled, Rouge Scan Status cannot be set to All Channel Scan.• In All Channel Scan mode, the device does not support all the AP functionality.• Rouge Scan Period: This parameter is enabled when Rouge Scan Status is set to All channel Scan. Thisparameter specifies the time period for which, the device scans each available channel to detect every wirelessdevice in its vicinity. By default, the value taken is 250ms. To configure, enter the time period value between 100-1000ms.3. Click OK, to save the configured parameters.: If you have changed any of the Wireless Properties parameters with an asterisk symbol marked against it, then rebootthe device.Channel Blacklist InformationA channel is blacklisted when a radar is detected in it. The Channel Blacklist Information table contains a list of all blacklistedchannels, which includes the following information:– Channel Number: A channel number of the blacklisted channel.– Reason: Indicates the reason for blacklisting a channel.– Time Elapsed: Indicates the time during which a channel is not operational.3.4.1.2 11n PropertiesTo configure 11n properties of the wireless interface, do the following:1. Navigate to CONFIGURATION > Wireless > Interface 1 > 11n Properties. The Wireless Interface-1 11nProperties screen appears.ORiNOCO® AP-800 and AP-8000 Installation and Management Guide 49