ORiNOCO® Access Points Installation and Management Guide ...

Device Configuration Using Web Interface• STP Frame Forward Status: Specifies STP frames on the network. By accepting the STP frames, any loops thatoccurs within a network can be avoided. If enabled, the STP frames in the system are bridged. When disabled, theSTP frames encountered on a network are terminated at bridge. By default, this feature is disabled. To configure,select Enable or Disable from the drop down menu.• Intra BSS Filtering: This parameter enables you to prevent the wireless clients within a BSS from exchangingtraffic. By default, this feature is disabled. To configure, select Enable or Disable from the drop down menu.3. To save the configured parameters, click OK.The various Filters supported by the device are described in the following sections:• Protocol Filters• Static MAC Address Filters• Advanced Filters• TCP/UDP Port Filters• Storm Threshold Filters• Packet Forwarding3.8.1 Protocol FiltersThe Protocol Filter blocks or forwards packets based on the protocols supported by the device.To configure Protocol Filter on the device, do the following:1. Navigate to CONFIGURATION > Filters > Protocol Filters. The Protocol Filters screen appears.ORiNOCO® AP-800 and AP-8000 Installation and Management Guide 77