ORiNOCO® Access Points Installation and Management Guide ...

Managing the device using SNMP7.3 Viewing the MIB Objects1. After configuring the pre-requisite information, load the MIB file.2. Navigate to Proxim under the private node.• To view all the objects, right-click and select Walk. This will display all the default and configured objects.• To view a particular object, select a particular object, right-click and click Get. This will display the selected configuredobject.7.4 Configuring the MIB Objects7.4.1 To Configure the Scalar Objects1. Select the object, right-click and click Set. This will display the existing configured values.2. To make changes to the existing value, double-click the object. This displays the list of values for configuration. Select thedesired values and click Ok.3. Click Execute to store the changes in the temporary buffer and proceed to SysMgmtCfgCommit table to Commit thechanges.7.4.2 To Configure the Tabular Objects1. Select the object, right-click and click Get Table. This displays the Table List.2. From the menu, click Set and drag the table entry for which you want to make the changes to the Set window.: You can configure table by configuring each entry that is available for the table or update the entire table as asingle entry.3. Select the table, right-click, and click Set.4. In the Set window, to add a row for a table, enter “0” and this will automatically create a row for a particular table.5. Add the required parameters and configure those parameters.6. Click Execute and proceed to SysMgmtCfgCommit table to Commit the changes.7.4.3 To apply the changes to the flash memory1. Navigate to deviceMgmt > SysMgmtCfgCommit, right-click and click Set.2. Set the value as 1 and click OK.3. Click Execute, this would configure the new value to the flash memory.ORiNOCO® AP-800 and AP-8000 Installation and Management Guide 200