ORiNOCO® Access Points Installation and Management Guide ...

More documents

Recommendations

Info

Device Configuration Using Web Interface3. Click OK, if you have changed any of the DHCP server parameters.3.9.1.1 DHCP Interface SettingsThe DHCP Interface Settings Table contains the following information:1. Net Mask: Specifies the subnet mask to be sent to the client along with the assigned IP address. The netmaskconfigured here should be greater than or equal to the netmask configured on the interface. To configure, enter theNet Mask.2. Default Gateway: Specifies the default gateway to be sent to the client along with the assigned IP Address. DefaultGateway is a node that serves as an accessing point to another network. To configure, enter the Default Gatewayaddress.3. Primary DNS: Specifies the primary DNS (Domain Name Server) IP address to be sent to the client. To configure, enterthe Primary DNS address.4. Secondary DNS: Specifies the secondary DNS IP address to be sent to the client. To configure, enter the SecondaryDNS address.5. Default Lease Period: Specifies the least time offered by the DHCP server, to the client on that interface. By default,it is taken as 86400 seconds. To configure, enter a value ranging from 3600 to 172800 seconds.6. Status: Specifies the status of DHCP server functionality over the interface. By default, it is disabled. To configure,select Enable or Disable from the drop down menu.7. Click OK, to save the configured parameters.3.9.1.2 DHCP Pool TableThe DHCP Pool Table contains the following information:1. Start IP Address: Specifies the Start IP Address of the pool.2. End IP Address: Specifies the End IP Address of the pool.3. Delete: This parameter allows you to delete the added pool entry.4. Click OK, if you have changed any of the DHCP Pool parameters.:• To enable DHCP Server, atleast one pool must be configured for it.• A pool entry can be deleted but not edited.3.9.1.3 Add an Entry to DHCP Pool TableTo add an entry to the DHCP Pool Table, click Add in the DHCP Server screen. The DHCP Pool Table Add Row screenappears.Figure 3-49 DHCP Pool - Add an EntryORiNOCO® AP-800 and AP-8000 Installation and Management Guide 90
Device Configuration Using Web Interface1. Configure the following parameters:• Pool Interface: Specifies the interface type (ethernet or wireless). The device supports only Bridge mode.• Start IP Address: See DHCP Pool Table• End IP Address: See DHCP Pool Table• Entry Status: Specifies the status of the pool entry being added. By default, it is enabled. To configure, selectEnable or Disable from the drop down menu.2. Click Add, to save the added entry.: You can add a maximum of five pool entries per interface.ORiNOCO® AP-800 and AP-8000 Installation and Management Guide 91
Page 1 and 2:
ORiNOCO® Access PointsInstallation
Page 3 and 4:
ContentsPreface . . . . . . . . . .
Page 5 and 6:
Licensed Features . . . . . . . . .
Page 7 and 8:
RADIUS Client Authentication Statis
Page 9 and 10:
PrefacePrefaceAbout this ManualCong
Page 11 and 12:
Introduction1This chapter contains
Page 13 and 14:
Introduction1.4 Managing and Monito
Page 15 and 16:
IntroductionThese MIB files are ava
Page 17 and 18:
Installation and Initialization2.1
Page 19 and 20:
Page 21 and 22:
Installation and Initialization2.5.
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Installation and Initialization: Th
Page 29 and 30:
Installation and Initialization4. O
Page 31 and 32:
Installation and InitializationFigu
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Device Configuration Using Web Inte
Page 39 and 40: Device Configuration Using Web Inte
Page 92 and 93: Device Management Using Web Interfa
Page 114 and 115: Device Monitoring Using Web Interfa
Page 128 and 129: Device Configuration, Management an
Page 140 and 141:
Device Configuration, Management an
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Managing the device using SNMP7This
Page 200 and 201:
Managing the device using SNMP7.3 V
Page 202 and 203:
Troubleshooting8.5 Gigabit PoE Inje
Page 204 and 205:
Troubleshooting8.7.4 Client Compute
Page 206 and 207:
Troubleshooting4. If WEP or WPA-PSK
Page 208 and 209:
TroubleshootingPreparing to Downloa
Page 210 and 211:
Troubleshooting8.8.5.2 Attaching th
Page 212 and 213:
Frequently Asked Questions (FAQs)AT
Page 214 and 215:
Frequently Asked Questions (FAQs)Q.
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Bootloader CLICThe Bootloader CLI p
Page 222 and 223:
Technical SpecificationsDThis chapt
Page 225 and 226:
Technical SpecificationsSecurity Fe
Page 227 and 228:
Technical SpecificationsHardware Sp
Page 229 and 230:
Technical SpecificationsAvailable C
Page 231 and 232:
Technical Specifications5 GHz CHANN
Page 233 and 234:
Technical SpecificationsEgyptIsrael
Page 235 and 236:
Technical SpecificationsRussia 36 (
Page 237 and 238:
Technical SpecificationsPolandPortu
Page 239 and 240:
Statement of WarrantyInternational
Page 241 and 242:
Technical Services and SupportTelep
show all

ORiNOCO® Access Points Installation and Management Guide ...

Create successful ePaper yourself

Delete template?

Save as template?