ORiNOCO® Access Points Installation and Management Guide ...

Device Configuration, Management and Monitoring using CLI6.7.10 System InformationTo configure the System Information entries, enter the following CLI commands.AP-00:7D:09 # configureAP-00:7D:09(config)#managementAP-00:7D:09(config-mgmt)# system-informationAP-00:7D:09(config-mgmt-sys-sysinfo)# ?Possible completions:emailexitfactory-resetgps-altitudegps-latitudegps-longitudelocationphone-numbersystem-nameEmail address of the contact person for the deviceExits Back to Global Configure ModeTo reset the device to factory settingsThe elevation of an access pointGPS Latitude ConfigurationGPS Longitude ConfigurationLocation of the systemPhone Number of the contact person for a deviceSystem Name ConfigurationAP-00:7D:09(config-mgmt-sysinfo)# email name@Organization.comAP-00:7D:09(config-mgmt-sysinfo)# system-name systemAP-00:7D:09(config-mgmt-sysinfo)# phone-number 1234567890AP-00:7D:09(config-mgmt-sysinfo)# location systemlocationAP-00:7D:09(config-mgmt-sysinfo)# gps-altitude 120AP-00:7D:09(config-mgmt-sysinfo)# gps-latitude 37.3321AP-00:7D:09(config-mgmt-sysinfo)# gps-longitude -121.8893AP-00:7D:09(config-mgmt-sysinfo)# factory-reset yesAP-00:7D:09(config-mgmt-sysinfo)#exitAP-00:7D:09(config-mgmt)# exitAP-00:7D:09(config)# exitAP-00:7D:09# show system-information// SYSTEM INFORMATION CONFIGURATION //System Uptime: 0d-00h:45m:02sSystem Description : ORiNOCO AP-8000-WD-v4.0.0System Name: systemContact Mail: name@Organization.comPhone Number : 1234567890Location Name: systemlocationGps Longitude : -121.8893Gps Latitude : 37.3321Gps Altitude : 120:• Setting factory-reset to yes or 1, will automatically reboot the device and the device will come up with default values.• Product Description differs based on the License file present on the board.ORiNOCO® AP-800 and AP-8000 Installation and Management Guide 180