ORiNOCO® Access Points Installation and Management Guide ...

Device Configuration Using Web Interface• PSK: Specifies the pass phrase that derives the PSK. To configure, enter a security key ranging from 8 to 64characters in the PSK box.: Special characters like - = \ " '? / space are not allowed while configuring the pass phrase.• Rekeying Interval: Specifies the interval at which the device will send group keys to all the associated clients.By default the Rekeying Interval value is set to 43200. To configure, enter a value ranging from 900 to 65535seconds.: When the encryption type is set to WPA-WPA2AES-TKIP, the device supports clients with the encryptiontype of either WPA-TKIP or WPA2-AES.d. 802.1x: Select 802.1x (Dot1x) from the Authentication mode drop down menu and the configuration screenappears.Figure 3-19 802.1x Authentication ModeConfigure the following parameters in 802.1x mode:• Encryption Type: Specifies the Encryption Type. By default, it is taken as WEP. To configure, enter theEncryption Type as either WEP, WPA-TKIP, WPA2-AES or WPA-WPA2AES-TKIP from the drop down menu.• Rekeying Interval: Specifies the interval at which the device will send group keys to all the associated clients.By default, the Rekeying Interval value is set to 43200. To configure, enter a value ranging from 900 to65535 seconds.3. Entry Status: Specifies the status for the security profile. By default, it is enabled. To configure, select the EntryStatus from the drop down menu.4. Then, click Add to save the new profile added with configured changes.:• You can add a maximum of 16 security profiles.• Supported Security Keys for a WDS link are:— For WEP Encryption, key length should be (ASCII 5/13/16) (Hex 10/26/32)— For AES or TKIP encryption, key length should be 16 ASCII characters or 32 Hex digits.— For 11na/11ng modes, WEP/TKIP Encryption will work only in Legacy (11 a/b/g) data rates.• Proxim do not recommend using WEP/TKIP in 11n mode.ORiNOCO® AP-800 and AP-8000 Installation and Management Guide 60