Sound - Denon-DN-M1050R-manual - SXS Events

vent 2courtesy production REMOTE CONTROL Phone: of CONNECTIONS and 0870 Audio-Visual 080 2342ServicesTo control the DN-M1050R remotely, refer to the example of remote control connections given below.www.sxsevents.co.ukTRACK(-) TRACK(+) FADER STARTemail: enquiries@sxsevents.co.ukENGLISH2382371234567891013222341622233152223214236235239STDBY/CUEPAUSEPLAYREC222422202217222319211415161718192021222324E.O.M.CUEEND CUEThe rating of REMOTE connector pin 22 (TALLY POWER SUPPLY) is +5 V, 80 mA maximum.Avoid currents in excess of the rating.■3 ABOUT MINIDISCSMiniDiscs allow a maximum of 74 minutes (stereo) of recording andplayback in a compact size.There are two types of MiniDiscs: those for playback only, andthose for recording and playback.Recording on discsMiniDiscs include a section in which the audio signals are recorded anda section in which such data as track numbers and track titles arerecorded.Playback only MiniDiscs• These discs are for playback only. Commercially available musicMDs are of this type.• These are laser discs, like regular compact discs.• Tracks on such discs cannot be edited.Section in which tracknumbers and track titlesare recorded (TOC)Section in which audiosignals are recordedRecordable MiniDiscs• These are magneto-optical discs on which both recording andplayback are possible. Recording is performed through magneticmodulation.• Re-recording is also possible.■The TOCWith MiniDiscs, after the audio signals are recorded, data used forchecking the tracks (TOC–Table of Contents) is also recorded on thedisc. This TOC data is used when playing the disc. In addition,editing is performed by rewriting the TOC data.When TOC writing starts, the “ TOC ” indicator flashes. Do notshake the main unit, press the main unit’s power button or unplugthe power cord while the TOC is being written. If the data is notrecorded properly, it will not be possible to play the disc.Accidental erasure prevention tabsThese tabs protect recordable MiniDiscs from accidental erasure.To avoid accidentally erasing the recording, open the tab so that thehole is exposed. (See the diagram below.) When this is done,“Protected” is displayed if you attempt to record, erase or otherwiseedit the disc, and the recording is protected. To record or erase thedisc, set the tab back to its original position (with the hole covered).Slide the tab.Hole exposedwww.sxsevents.co.uk■ Handling MiniDiscsMiniDiscs are housed in cartridges, so there is no need to worryabout dirt and scratches. However, dirty or warped cartridges maycause malfunction. Be careful of the following to ensure longlasting,high quality sound:• Do not touch the disc surface directly.• Do not open the shutter by hand.• Do not place MiniDiscs in dusty, dirty or humid places.• Do not place MiniDiscs in places exposed to direct sunlight or hightemperatures.CleaningUse a dry cloth to gently wipe dirt or dust off the cartridge. Do notapply excessive force.13