Sound - Denon-DN-M1050R-manual - SXS Events

vent courtesy production Phone: of and 0870 Audio-Visual 080 Select the 2342A-B erase Servicesmode.Turn the select knob and select “A-B Erase?”.www.sxsevents.co.ukemail: enquiries@sxsevents.co.ukENGLISH8NOTE: Cue Erase? is not displayed if no cue signals areset.(5) Erasing Specific Sections ‹A-B erase function›1 Load the cartridge.Erase the set section.Press the ERASE button.ERASEDisplayed if only the A point is set.2Set the section to be erased.Use the SCAN or SEARCH dial to find the starting point.Displayed if only the B point is set.Set the starting point.Press the “A” (or “B”) button.(Set the B or A point, as necessary.)3Lit9-1Press the ERASE button again.ERASEA-B erase is rehearsed.4 Use the SCAN or SEARCH dial to find the end point.Set the end point.Press the “B” (or “A”) button.NOTE: If both the A and B points are set, the A-B sectionis rehearsed andis displayed thefirst time the ERASE button is pressed.Press the ERASE button again.5LitLit* The ERASE button turns off.Set the edit mode.Press the EDIT button.EDITEDIT9-26LitTRACK NO. SINGLE REMAIN NEXT NO.m s fThe A-B section is erased and the mode returns to the editmode.7Set the erase mode.Press the ERASE button.ERASE* The ERASE button lights.EDITTRACK NO. SINGLE REMAIN NEXT NO.m s fLitEDITDisplay during the A-B erase operationThis is displayed if no B point is set. If youcontinue without setting the B point, the endof the track is set as the B point, and thesection from the A point to the end of thetrack is rehearsed and erased.This is displayed if no A point is set. If youcontinue without setting the A point, thebeginning of the track is set as the A point,and the section from the beginning of thetrack to the B point is rehearsed and erased.www.sxsevents.co.ukNOTE:The A-B erase operation cannot be performed if the A or B pointis set on a track for which cue signals are set.31