SBC81870 SERIES USER'S MANUAL VERSION A1 SEPTEMBER ...

More documents

Recommendations

Info

<strong>SBC81870</strong> Intel ® Pentium ® M w/ DDR/VGA/Dual LAN2.3 How To Set The JumpersYou can configure your board by setting jumpers. Jumper isconsists of two or three metal pins with a plastic base mountedon the card, and by using a small plastic "cap", Also known asthe jumper cap (with a metal contact inside), you are able toconnect the pins. So you can set-up your hardwareconfiguration by "open" or "close" pins.The jumper can be combined into sets that called jumperblocks. When the jumpers are all in the block, you have to putthem together to set up the hardware configuration. The figurebelow shows how this looks like.JUMPERS AND CAPSIf a jumper has three pins (for examples, labelled PIN1, PIN2,and PIN3), You can connect PIN1 & PIN2 to create one settingand shorting. You can either connect PIN2 & PIN3 to createanother setting. The same jumper diagrams are applied allthrough this manual. The figure below shows what the manualdiagrams look and what they represent.Hardware Configuration 11
<strong>SBC81870</strong> Intel ® Pentium ® M w/ DDR/VGA/Dual LANJUMPER DIAGRAMSJumper Caplooks like this2 pin Jumperlooks like this3 pin Jumperlooks like thisJumper Blocklooks like thisJUMPER SETTINGS12 pin Jumper close(enabled)Looks like this113 pin Jumper2-3 pin close(enabled)Looks like this11 2Jumper Block1-2 pin close(enabled)Looks like this1 212Hardware Configuration
Page 2 and 3: SBC81870 Intel ® Pentium ® M w/ D
Page 66 and 67:
SBC81870 Intel ® Pentium ® M w/ D
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116:
show all

SBC81870 SERIES USER'S MANUAL VERSION A1 SEPTEMBER ...

Create successful ePaper yourself

Delete template?

Save as template?