KM-1530 Instruction Handbook - KYOCERA Document Solutions

CHAPTER 6 COPIER MANAGEMENT(2) How to make default settingsPress and hold both of the copy exposure adjustment keys1for 3 seconds. “FOO” (default code) appears on the copyquantity display.5Enter the paper width by pressing the Zoom (+) or Zoom (-).The paper width can be set between 100 mm and 297 mm in1 mm increments.-‘b 200%D”6Press the enter key. The display returns to that for step 2. Toend the making of default settings, proceed to step 11.2 The default code changes each time the Zoom (+) key orZoom (-) key is pressed or when numeric keys are pressed.Select the desired default code by referring to the tableshown in “(1) Default settings”.7Enter the copy limit (250 copies or lower) by pressing theZoom (+) or Zoom (-).3Press the enter key.If “F01” or “F27” is selected, the report will be printed out. Besure to check in advance that A4 paper is loaded in thedrawer. Proceed to step 4.If “F13” is selected, proceed to step 5.If “F16” is selected, proceed to step 7.If a code other than the above is selected, proceed to step 989Press the enter key. The display returns to that for step 2. Toend the making of default settings, proceed to step 11.The setting code changes each time the Zoom (+) key orZoom (-) key is pressed. Select the desired default code byreferring to the table shown in “(1) Default settings”.10Press the enter key. The display returns to that for step 2. Toend the making of default settings, proceed to the next step.11Press the Zoom (+) or Zoom (-) key to display “FOO” andpress the enter key. The display indication changes from thedefault code to the number of copies.4When the report is printed out, the display returns to that forstep 2. To make other settings, perform the respectiveprocedures (see below). To end the making of defaultsettings, proceed to step 11.6-8