KM-1530 Instruction Handbook - KYOCERA Document Solutions

.,.,CHAPTER 7 OPTIONAL EQUIPMENTleading edge of the originals into the DF as far as they willgo.>“;I_Press the Auto Selection key to light the indicator.1 200a +..L@ How to set originals on the platenWhen using an original that cannot be set in the DF, such as a bookor magazine, open the DF and place it on the platen.Do not set originals exceeding the limit indicated on the stickerattached on the rear original insertion guide. Setting more originalsthan specified may cause original misfeed.: ,,I ._ Hold the DF open/close handle and open the DF.’ Before opening the DF, check that no original is present onthe original table or original eject cover. If present, theoriginal may fall off when the DF is opened.@ Auto selection modeAutomatically detects the size and brightness of every original.Copies are made onto paper of the same size as the originals.* Optional memory board is required.2 Set the original with the side to be copied facing downward.Be sure to align the original with the original size scales.• Up 50 sheets of paper (75 g/m2- 80 g/m’) can be set in the DF forthis mode.. Originals used in this mode are limited to 11” x 17”, 11” x 8 1/2”,8 1/2” x 14” and 8 1/2” x ll”(A3, A4, B4 and B5), and the width ofall original must be the same.7-2