KM-1530 Instruction Handbook - KYOCERA Document Solutions

7-1CHAPTER 7 OPTIONAL EQUIPMENT(1) ADF (Automatic document feeder)@ DF part namesAutomatically feeds multiple sheet originals one by one for scanning.@ Originals that can be used with the DF. Sheet originals only. Original weights: Single-sided original of 35 g/m2 to 160 g/m2. Original sizes: 11” x 17"/A3 (maximum) to 5 1/2” x 8 1/2 (vertical)/A5R (minimum)= Capacity: 70 sheets (11” x 8 1/2"/A4 and smaller, 75 g/m2 or 80 g/m?50 sheets (8 1/2” x 14"/B4 and larger, 75 g/m2 or 80 g/m2)50 sheets in auto selection mode@ Original table(Place the originals here.)@ Original insertion guides(Adjust the guides to the width of the originals.)@ DF open/close handle(Hold this handle when opening and closing the DF.)@ Original eject cover(Copied originals are stored here.)@ DF original cover(Open this cover to remove an original midfed in the DF.)@ Precautions for the use of DFDo not use any of the originals given below with the DF. Also do notset originals with punch holes or tear-off strips positioned at theleading edge.* Transparency films. Carbon paper and extremely creased or folded originals, originals ofsoft material such as vinyl. Non-square originals, wet originals, originals with adhesive tape orglue. Originals bundled with a paper clip or staple (if inevitable, removethe paper clip or staple and straighten out the creases and foldsbefore setting the originals). Clipped out originals, originals with slippery surface. Originals with still-wet whiteout. Originals with creases (if inevitable, straighten out the creasesbefore setting the originals)@ How to set originals in the DF1Adjust the original insertion guides to the original size.* Before setting the originals in the DF, check that no originalfrom the previous operation is remaining on the originaleject cover. Originals remaining on the original eject covermay cause original misfeed.