VistaScan Mini manual - PROFI - dental equipment

More documents

Recommendations

Info

EN21Status LED is yellow:• Do not feed any more image plates.• Once the scanning process has beencompleted the grip mechanism automaticallyreturns to start. Remove the empty lightprotection cover. Status LED changes fromyellow to green.• The X-ray exposure will be saved in DBSWIN.• Either insert a new image plate for scanning orturn off the appliance at the On/Off switch.When the On/Off switch is pressed for3 seconds then the appliance shutsdown. This can take a few moments(green and blue LEDs blink alternately,additionally for VistaScan Mini Plus thedisplay will show a progress bar). Theappliance will shut down completely.Do not move the appliance during thisphase.When switched off the VistaScan Mini can becovered and protected using the protectivecover.28
18.5 Erasing the image dataAfter scanning the image plate passes automaticallythrough the erasure unit. Image data stillheld on the image plate will be erased. Afterwardsthe image plate falls into the collectiontray.22Special mode "Erase"The image plate must be erased again if:• the image plate has been stored and not usedfor longer than 24 hours.• the data on the image plate durch has notbeen (completely) erased due to a malfunction ENof the VistaScan Mini. (Error message fromsoftware)The special mode enables the erasureunit in VistaScan to be activated alone.No image data will be transmitted to thesoftware.To erase again:• Choose the special mode "Erase" in the software.• Place the open light protection cover with itsimage plate in the insert slot.• Slide the image plate out of its light protectioncover downwards into the appliance until theimage plate is automatically taken up by thetransport. 29
Page 1: VistaScan MiniVistaScan Mini PlusEN
Page 4 and 5: 1. GeneralImportantInformation1.1 N
Page 6 and 7: EN2. Safety2.1 General Safety Notes
Page 8 and 9: 4. Delivery ContentsVistaScan Mini
Page 10 and 11: 5. System requirementsTo operate Vi
Page 12 and 13: 7. Functional layout1 2EN3134567128
Page 14 and 15: 8. Functional DescriptionVistaScan
Page 16 and 17: 10.2 Set-up alternativesTable Set-u
Page 18 and 19: 12.2 X-ray device settingsCheck the
Page 20 and 21: 13.2 Working with image platesImage
Page 22 and 23: 16. Protective coverThe protective
Page 24 and 25: 18.2 X-ray exposuresDanger of infec
Page 26 and 27: ENOperational LEDsOperationalNot re
Page 30 and 31: 19. Disinfection andCleaningOnly us
Page 32 and 33: 19.5 VistaScan Mini1.Damage to the
Page 34 and 35: Trouble-shooting21. Tips for Operat
Page 36 and 37: ENProblem Probable cause Solution13
Page 38 and 39: EN21.2 Display error messageProblem
Page 40: DÜRR DENTAL AGHöpfigheimer Strass

VistaScan Mini manual - PROFI - dental equipment

Create successful ePaper yourself

Delete template?

Save as template?