Manual - Unvented Gas Log Heater or Vented Decorative Appliance

CDVSC7 & CDV7 Series Gas Fireplaceglass removal & ROCK WOOL PLACEMENTGlass Frame Removal1. Remove upper and lower louvers.2. Release the clamps on the bottom of the fireplace.Figure 613. Tilt glass frame out and lift glass frame up until it clearsthe hook on top of the frame.4. Set glass frame aside.CAUTIONEach clamp has a quick springforce. When reinstallingclamps, keep fingers clear.Glass Frame!WARNINGHOT GLASS WILLCAUSE BURNS.DO NOT TOUCH GLASSUNTIL COOLED.NEVER ALLOW CHILDRENTO TOUCH GLASS.NOTE: A mesh glass cover is available for this fireplace.This cover is recommended to reduce the severity of burnsin case of accidental contact. Refer to the Accessories liston Page 55.!AVERTISSEMENTUn panneau vitré chaud peutcauser des brûlures.rock wool placement Laissez refroidir le panneau1. For best results in flame appearance vitré avant d’y and toucher. operation:Ne laisser jamais les enfantstoucher le panneau vitré.a. If your fireplace was supplied with three (3) 8-gram bags of rock wool embers: Use one (1) 8gram bag or rock wool for propane/LP modelsand up to three (3) bags of rock wool for naturalgas models depending on the size of your fireplace.b. If your fireplace was supplied with one (1) 40-gram bag of rock wool embers: Use no more than 1/5(8 grams) of the total amount of rock wool suppliedin the 40 gram bag for propane/LP models and up to3/4 of the 40 gram bag of rock wool for natural gasmodels depending on the size of your fireplace.Use the following chart as a guide to how much rockwool to use:Models Natural Gas LPCDV33, CDV36 24 grams max. 8 grams max.CDV42, CDV47 30 grams max. 12 grams max.Clamps -2 on 33/36 Models,3 on 42/47 ModelsFigure 61 -Removing Glass Frame - CDVR Series ShownWARNINGCover withRock WoolBurnerFigure 62 - Placement of RockWool on BurnerFP2648BDV rock wool placeFP2297FP2297remove glassThe use of too much rock wool couldcause flame to burn poorly and may causesooting.FP26482. Pull the rock wool apart into dime-sized pieces orsmaller. Cover the entire surface of the burner with onethin layer of rock wool.3. Place the logs on the burner. Refer to the “Log PlacementSection”. Light the unit and after 15 minutes checkburner flame and glow. Adjust embers as necessary toachieve an even and clean flame.46 69D3011