Vashon (Avanti DVS FS) - Avalon

Optional Equipment 318 Remove the regulator from the front of the gas control valve. Replace with the propane regulator,using the new gasket and screws included with the regulator. NOTE: Leak test this area after theheater is installed, gas is connected, and the main burner is lit.Align the regulatorgasket so it is flatand the two tabs fitthrough the twoholes on thegasket.NOTE: These holes stripeasily. Use a handscrewdriver and tighteneach screw evenly.VENTHILOThese screws hold theregulator in place.NOTE: use the newscrews included withthe regulator.VENTHIONPhillipsScrewdriverLOOTLPIOFFPILOT ADJRegulator GasketNOTE: use the new gasketincluded with the regulator.LP (propane) regulators have a11.0 2.7 stamped here.9 Place the included propane label over the natural gaslabel on top of the gas control valve.10 Make the gas line connection, start the heater andthoroughly leak-test all gas connections and theregulator. Check the pilot. Adjust if necessary.THIS CONTROLHAS BEENCONVERTED TO LP3/8ÓONThermocoupleThermopileOTLPILOT ADJCover Screw GasketPIOFFNeedle ValveMicro (1/16Ó)StandardScrewdriverCover ScrewPilot HoodStandardScrewdriverBlower (Part # 98900127)The optional blower boosts airflow through the convection channel, increasing heat transfer. Followthe directions below to install.Hint We strongly suggest installing the blower prior to installing the stove. It can beinstalled after installation, but it is more difficult.4 Remove the control cover from the front of the stove (see the directions to the right).Remove the four screwsholding the control panelin place.ControlPanel1/4" NutdriverLay the control panel facedown so the area behind itmay be accessed.Travis Industries 93508102 091002