Vashon (Avanti DVS FS) - Avalon

More documents

Recommendations

Info

6 Installation (for qualified installers only)Installation Warnings! Failure to follow all of the requirements may result in property damage, bodily injury, or even death.! This heater must be installed by a qualified installer who has gone through a training program for theinstallation of direct vent gas appliances.! This appliance must be installed in accordance with all local codes, if any; if not, follow current ANSIZ223.1 or NFPA 54 in the USA or the current CGA B149 in Canada.! In Manufactured or Mobile Homes this appliance must be installed to the applicable Mobile HomeStandards: CAN/CSA Z240 MH, the Manufactured Home Construction and Safety Standard, Title 24CFR, Criteria for Manufactured Home Installations, Sites and Communities, and/or ANSI/NFPA 501A.This appliance may be installed in Manufactured Housing only after the home is site located.! This appliance is designed for natural gas or propane (LP). Check the sticker on top of the gas controlvalve.! All exhaust gases must be vented outside the structure of the living-area. Combustion air is drawn fromoutside the living-area structure.! Notify your insurance company before hooking up this appliance.! The requirements below are divided into sections - all requirements must be met simultaneously.Packing List¥ Vashon (Avanti DVS FS) ¥ OwnerÕs Manual ¥ Log Set with Embers ¥ Propane Conversion KitInstallation PreparationHINT:HINT:HINT:HINT:Stove ClearancesStraightInstallationsIf converting to LP, convert the appliance prior to installation.Install the logs last - they are fragile.When determining the location of the stove, locate the wall studs (for horizontal penetrations)and ceiling trusses (for vertical penetrations). You may wish to adjust the stove positionslightly to ensure the vent does not intersect with a framing member.Fumes and smoke from the paint curing and oil burning off the steel may occur the first timeyou start this heater. This is normal. We recommend you open windows to vent the room.CornerInstallationsWith this clearance, the ventis 12-7/8Ó from the wall.10"Min.5" Min.With this clearancethe vent is 6-3/8Ó fromthe back wall, 17-7/8Ófrom the side wall.MeasureClearances tothe Stove Top5" Min.MeasureClearances tothe Stove Top45¡Mobile Home Requirements¥ When the stove is installed in a mobile home, it must be bolted to the floor and theappliance grounded (use the optional blower with a grounded circuit or other suitablegrounding method - current ANSI/NFPA 70 or CSA C22.1).Travis Industries 93508102 091002
Installation (for qualified installers only) 7Heater Placement Requirements¥ Heater must be installed on a level surface capable of supporting the heater and vent¥ Due to the high temperature of the heater, it should be located out of traffic and away fromfurniture and draperies. Heater must be placed so no combustibles are within, or canswing within 36Ó of the front of the heater (e.g. drapes, doors)? When placed in a location where the floor to ceiling height is under 7 feet, the installationis considered an alcove and must meet the following requirements:¥ The alcove floor to ceiling height must be at least 58Ó tall¥ The alcove must not be more than 45Ó deep before the ceiling returns to 7Õ¥ The alcove must be at least 42Ó wide¥ The heater must not be placed so the vents below or above the door, along the sides ofheater, or along the back of the heater can become blocked.Floor Protection Requirements¥ When the stove is installed directly on carpeting, vinyl or other combustible material otherthan wood flooring or a high pressure laminate wood floor, the stove must be installed ona metal or wood protection panel extending the full width and depth of the heater(Minimum 22-1/8Ó wide by 15-5/8Ó deep).Gas Line Installation! The gas line must be installed in accordance with all local codes, if any; if not, followcurrent ANSI Z223.1 or NFPA 54 in the USA and the current CGA B149 in Canada.! The heater and gas control valve must be disconnectedfrom the gas supply piping during any pressure testing ofthat system at test pressures in excess of 1/2 psig (3.45kPA). For pressures under 1/2 psig (3.45 kPA), isolatethe gas supply piping by closing the manual shutoffvalve.¥ This heater is designed for natural gas but can beconverted to propane. Check the sticker on the top ofthe gas control valve to verify the correct fuel is used.¥ Leak test all gas line joints and the gas control valve priorto and after starting the heater.¥ The gas inlet accepts a 3/8Ó F.P.T. Fitting¥ The location of the gas inlet is shown below¥ A manual shutoff valve is required for installation (it mustbe located within 3Õ (910 mm) of the heater)Gas Inlet Pressure¥ With the heater off, the inlet pressure must meet therequirements listed in the table below? If the pressure is not sufficient, make sure the piping used is large enough and the totalgas load for the residence does not exceed the amount supplied.? The supply regulator (the regulator that attaches directly to the residence inlet or to thepropane tank) should supply gas at the suggested input pressure listed below. Contactthe local gas supplier if the regulator is at an improper pressure.Standard Input PressureNatural Gas 7Ó W.C. (1.74 Kpa)Propane11Ó W.C. (2.73 Kpa)Travis Industries 93508102 0910025-7/8"3"1/4"
Page 2 and 3: 2 Safety Precautions¥ IF YOU SMELL
Page 4 and 5: 4 Table of ContentsIntroductionIntr
Page 8 and 9: 8 Installation (for qualified insta
Page 10 and 11: 10 Installation (for qualified inst
Page 12 and 13: 12 Installation (for qualified inst
Page 15 and 16: Installation (for qualified install
Page 17 and 18: Installation (for qualified install
Page 19 and 20: Operation 19Starting The Pilot Flam
Page 21 and 22: Adjusting the Blower Speed (optiona
Page 23 and 24: Maintenance 237 To check the door s
Page 25 and 26: Maintenance 25Wiring DiagramThermop
Page 27 and 28: Warranty 27To register your TRAVIS
Page 29 and 30: Optional Equipment 293 Follow the d
Page 31 and 32: Optional Equipment 318 Remove the r
Page 33 and 34: Optional Equipment 335 Use the incl
Page 35 and 36: Remote ThermostatOptional Equipment
Page 37 and 38: Optional Equipment 37Travis Industr
Page 39 and 40: ADDENDUM #1 Interior Masonry Chimne

Vashon (Avanti DVS FS) - Avalon

Create successful ePaper yourself

Delete template?

Save as template?