Vashon (Avanti DVS FS) - Avalon

More documents

Recommendations

Info

34 Optional EquipmentThermostat (Part # 99300650)! Do not connect 120 VAC to the gas control valve or wiring of this unit.1 Route the thermostat wire through the back of the right side panel (there is a hole beneath the on/offswitch) and attach to the on/off switch (see the illustration below).Back of on/off switchcRemove the greenjumper wire.aOpen the rightside panel.Back ofon/offswitchbRoute thewire behindthe panel tothe on/offswitch.dAttach the quick connectsfrom the wire to the two postson the on/off switch(orientation does not matter).2 Pull through all the slack on the wire (you may wish to wrap the wire in electrical tape to preventdamage to the wire). Determine a location for the thermostat that is within range of the 50Õ length ofthermostat wire. It should be centralized in the room and away from the heater. The wire may berouted externally on the wall or behind the wall (preferred).3 Cut the thermostat wire so there is approximately 6" of slack (NOTE: Do not splice thermostat wirestogetherÐthis leads to too much electrical resistance). Follow the directions below to install thethermostat.aPull the cover off the thermostat50 60 70 80 90Robertshaw50 60 70 80 90bRun the thermostat wiresthrough the wall (cut off excesswire, leaving 6Ó of slack).dAttach the thermostat tothe wall through thesetwo holes.cExpose 1/2Ó of wire andattach to these two posts.eRe-attach the coverremoved in step ÒaÓ.StandardScrewdriverTravis Industries 93508102 091002
Remote ThermostatOptional Equipment 35! Do not connect 110-120 VAC to the gas control valve or wiring system of this unit.¥ Follow the instructions included with the remote thermostat for installation.Using the Remote ThermostatThe remote thermostat has a 1 to 2 minute lag time between the time the thermostat is turned up andthe heater turns on. Included with the remote thermostat is a set of instructions that details theoperating characteristics of this optional component.Gold Door (part # 99300523)Follow the directions below to install the optional gold door.Remove the black door by slidingit up and off the door frame.Slide the gold door onto the doorframe.HINT: align the bottom joggleclips over the brackets on thedoor and slide into place. Thenlift up slightly on the door toattach the upper clips.The door is held in place witheight joggle clips.DoorDoor FrameWARNING:Clean the gold surface prior to starting the stove. Any marks left on the gold may become etched-inby the heat of the stove. Use denatured alcohol and a soft cloth to clean.Soft ClothDenaturedAlcoholTravis Industries 93508102 091002
Page 2 and 3: 2 Safety Precautions¥ IF YOU SMELL
Page 4 and 5: 4 Table of ContentsIntroductionIntr
Page 6 and 7: 6 Installation (for qualified insta
Page 8 and 9: 8 Installation (for qualified insta
Page 10 and 11: 10 Installation (for qualified inst
Page 12 and 13: 12 Installation (for qualified inst
Page 15 and 16: Installation (for qualified install
Page 17 and 18: Installation (for qualified install
Page 19 and 20: Operation 19Starting The Pilot Flam
Page 21 and 22: Adjusting the Blower Speed (optiona
Page 23 and 24: Maintenance 237 To check the door s
Page 25 and 26: Maintenance 25Wiring DiagramThermop
Page 27 and 28: Warranty 27To register your TRAVIS
Page 29 and 30: Optional Equipment 293 Follow the d
Page 31 and 32: Optional Equipment 318 Remove the r
Page 33: Optional Equipment 335 Use the incl
Page 37 and 38: Optional Equipment 37Travis Industr
Page 39 and 40: ADDENDUM #1 Interior Masonry Chimne

Vashon (Avanti DVS FS) - Avalon

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?