Vashon (Avanti DVS FS) - Avalon

34 Optional EquipmentThermostat (Part # 99300650)! Do not connect 120 VAC to the gas control valve or wiring of this unit.1 Route the thermostat wire through the back of the right side panel (there is a hole beneath the on/offswitch) and attach to the on/off switch (see the illustration below).Back of on/off switchcRemove the greenjumper wire.aOpen the rightside panel.Back ofon/offswitchbRoute thewire behindthe panel tothe on/offswitch.dAttach the quick connectsfrom the wire to the two postson the on/off switch(orientation does not matter).2 Pull through all the slack on the wire (you may wish to wrap the wire in electrical tape to preventdamage to the wire). Determine a location for the thermostat that is within range of the 50Õ length ofthermostat wire. It should be centralized in the room and away from the heater. The wire may berouted externally on the wall or behind the wall (preferred).3 Cut the thermostat wire so there is approximately 6" of slack (NOTE: Do not splice thermostat wirestogetherÐthis leads to too much electrical resistance). Follow the directions below to install thethermostat.aPull the cover off the thermostat50 60 70 80 90Robertshaw50 60 70 80 90bRun the thermostat wiresthrough the wall (cut off excesswire, leaving 6Ó of slack).dAttach the thermostat tothe wall through thesetwo holes.cExpose 1/2Ó of wire andattach to these two posts.eRe-attach the coverremoved in step ÒaÓ.StandardScrewdriverTravis Industries 93508102 091002