Installation Manual - Model 5 - Tundra Process Solutions Ltd.

REV D (10-22-10)INSTALLATION MANUAL – D5Section 3. Tools and Special EquipmentThis section lists required tools and special fixtures required for assembly.The following provides a list of equipment and tools needed to complete assembly of the DynaPumpUnit. Most of these tools should be available locally. If tools are unavailable, please contact yourDynaPump sales representative for a quotation on a particular item or items.Recommended Tools• Channel locks – ranging from 6.5-inch, 10-inch and 20-inch.• End wrench set, standard sizes, US and Metric• Allen wrench set, US and Metric• Adjustable wrench – 24-inch• Monkey wrenches – 15-inch and 18-inch• Wire strippers, wire cutters and crimpers• Screwdriver set, standard and electronic (small size), phillips and flat blade• Diagonal cutting pliers, 8-inch• Deep impact gun, 3/4-inch drive, 1 1/4-inch deep-impact socket• A set of 3/4-inch drive sockets, including 1 5/8-inch• A set of 1/2-inch drive sockets that range from 3/8-inch to 1-1/4-inch• Drill set, cordless, with drill bit set 1/16-inch to 1/2-inch reduced shank• Thread restoring tool and tap set• Hacksaw• Utiity knife• Sledge hammer, 3-pound• Tape measure, 36-inch• Punch/chisel set• Vice grip or bench vise, capacity to hold 5-inch• Measuring level, liquid, 2-inch• Shovel• Circuit multimeter (with case), digital or analog, with electrical tester and amp probe• Chain with hook ends• Strap wrench vice grip• Zerk fitting, 1/8-inch (pkg 10)• Cable cutter• Tool box, side mount• Tool box, pack ratSECTION 3 – TOOLS & SPECIAL EQUIPMENT6