Installation Manual - Model 5 - Tundra Process Solutions Ltd.

REV D (10-22-10)INSTALLATION MANUAL – D5Computer Equipment• Laptop computer, equipped with Microsoft-equivalent Office software• Ladder logic software (current installed versions)• Service Tech CD (current version)• COM cableDynaPump Equipment• Counterweight fill hose (P/N DP00315)• Coupler alignment tool (No DP P/N)• Cover plate, 2-inch hose (P/N 200-2SAE108)• Cable removal tool (P/N D00166)• V-block dolly, 1 each• Base assembly supports, 2 each• Counterweight storage stand, 4 eachSpecial Equipment• Air compressor multiplier, 5 to 1 ratio• Open capstan winch, rated at 800 pound pulling capacity• Wire cable puller for 9/16-inch cable, rated at 500 lbs pull force• Braided rope, 250 feet of 1/2-inch poly Dacron or polyester• Forklift or mobile crane rated at 21,000 lbs lifting capacity• Stationary crane with two trucks, each rated at a minimum lifting capacity of 7,000 lbs. The minimumcrane runway dimensions should be 10 x 40 feet with a lifting height capability of at least 8 feet.• Air compressor rated at 50 cfm @120 psi. The compressor must have a dryer installed so that thereis no water in the delivered compressed air.• Electric-powered portable grinding tool• Ratchet chain hoist, rated at 3000-pounds• Hydraulic jack, bottle, 12-ton• Locks, keyed alike (order qty 4 min)First Aid Equipment• First aid kit• H 2 S Monitor for toxicity• Fire extinguisher, ABC-typeSECTION 3 – TOOLS & SPECIAL EQUIPMENT7