Installation Manual - Model 5 - Tundra Process Solutions Ltd.

REV A (05-01-09)INSTALLATION MANUAL – D5Section 4. Unpacking and Pump Unit PreassemblyThis section discusses unpacking, and preassembly requirements (if required) after shipment.NOTE:If the unit is shipped within North America, preassembly has likely beencompleted. The operator can skip Section 4: Unpacking and PumpingUnit Preassembly and proceed to Section 5: Installation, then continuewith each process until commissioning of the unit has been completed.Shipment TypesDynapump Pumping systems may be shipped in two ways according to location:• Domestic (North America) - Arrives by flatbed truck, pump units are preassembled andready for installation• International – Arrives packaged in a shipping container, and pump units must beassembled in accordance with this manual.When the shipping container arrives, verify that the contents match the shipping documents.Carefully unpack the container using either a crane or a forklift rated for 8,000 pounds. Remove thesmaller parts and packages first, followed by the large structural base, counterweights units, hydrauliccylinder, and the Power Unit. Each shipping container may contain parts or assemblies for more thanone pump.SECTION 4 – UNPACKING AND PUMP UNIT PREASSEMBLY9