Installation Manual - Model 5 - Tundra Process Solutions Ltd.

More documents

Recommendations

Info

REV A (05-01-09)INSTALLATION MANUAL – D5DynaPump, Inc.Corporate Headquarters:2441 High Timbers Suite 200The Woodlands, TX 77380(281) 973-0050Manufacturing and Technology Center:9324 Corbin AvenueNorthridge, CA 91324(818) 407-7577, FAX (818) 407-7578Website: www.dynapumpinc.comNOTE:The information contained in this document is the sole property ofDynapump Inc. Any reproduction in part or whole without writtenpermission is prohibited.Document # MAN-INST-001 Rev A Issue Date: May 1, 2009
REV D (10-22-10)INSTALLATION MANUAL – D5REVISION RECORDREV DATE SECTION DESCRIPTIONA 5-01-09 - Initial ReleaseB 6-10-09C 10-01-10D 10-22-105App AApp B44444AB34CPage 21: Update crane selection criteria (step 2)Page 22: Add step for oil check in CWT site glass (step 4)Figure A-2: Replace pumping unit figure with currentFigure B-1: Update <strong>Installation</strong> Checklist to add item 42Page 3: Change part number for installation & interface kitPage 4: Corrected dimension of concrete piersPages 1-15: Update pumping unit componentsPages 23-28: Add new section: “Pre-installation Well HeadVerification”Pages 30-32: Update cylinder alignment requirementsPage A-3: Corrected dimensions on Figure A-3Pages B-2, B-3: Update <strong>Installation</strong> ChecklistPage 6-8: Update tools and special equipmentPage 41: Add external shutdown circuitry optionAdd Appendix C for historical configurationsREVISION RECORD
Page 1: Installation Manualfor the D5 Pumpi
Page 5 and 6: REV D (10-22-10)INSTALLATION MANUAL
Page 7 and 8: REV A (05-01-09)INSTALLATION MANUAL
Page 15 and 16: REV (-01-)INSTALLATION MANUAL - D5
Page 19 and 20: REV C (10-01-10)INSTALLATION MANUAL
Page 53 and 54:
REV C (10-01-10)INSTALLATION MANUAL
Page 55 and 56:
Page 57 and 58:
Page 59:
show all

Installation Manual - Model 5 - Tundra Process Solutions Ltd.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?