Installation Manual - Model 5 - Tundra Process Solutions Ltd.

REV A (05-01-09)INSTALLATION MANUAL – D57. Mount four cable sheaves to the tension plate. Secure with two 1-1/8 hex cap screws 6-inches long, and four 1-1/8-inch flat washers, and two lock washers and nuts. Install four3/8-inch roll pins into the plate with a hammer (see Figure 9).BaseCablesheavesRoll PinFigure 9. Installing Cable Sheaves8. Mount a PVC pipe below the downpipe, and secure the upper and lower counterbracessegments, attaching the two pieces together with bolts (see Figure 10).DownpipePVCpipeCounterbraceFigure 10. PVC and Downpipe Connection9. Hoist the pulley assembly using a metal support rod through a pair of 2-inch holes locatednear the top of the pulley support (see Figure 11).CablehoistPulleyFigure 11. Hoisting Pulley AssemblySECTION 3 – TOOLS & SPECIAL EQUIPMENT12