Installation Manual - Model 5 - Tundra Process Solutions Ltd.

More documents

Recommendations

Info

REV C (10-01-10)INSTALLATION MANUAL – D516. On the other (base) end of the down pipe, secure the counterweight with a bent wire andattach to the back of the pipe (see Figure 18).Figure 18. Securing the Counterweight17. Install the position sensor and bracket assembly to the tension bar (see Figure 19).SensorbracketSensorPositionsensor cableFigure 19. Position Sensor and Sensor Bracket18. Electronically connect the transducer cable (see Figure 20).TransducercableFigure 20. Transducer WiringSECTION 3 – TOOLS & SPECIAL EQUIPMENT15
REV C (10-01-10)INSTALLATION MANUAL – D519. Note the attachment points on the Power Unit for the transducer and position sensor.This connection will be performed during final installation (See Figure 21).TransducerconnectionPosition sensorconnectionFigure 21. Cable Attachment Location on Power Unit20. Begin installation of the pulley tension rope by stringing the 7/16-inch cable from the rollthrough the base. The pumping unit requirement is for 140 feet of cable (70 ft perpulley). See Figure 22.Pulley tensionropeFigure 22. Cable <strong>Installation</strong>21. Route the cable through the innermost groove of the first pulley (see Figure 23).Cable thrufirst pulleyFigure 23. Routing the PulleySECTION 3 – TOOLS & SPECIAL EQUIPMENT16
Page 1 and 2: Installation Manualfor the D5 Pumpi
Page 3 and 4: REV D (10-22-10)INSTALLATION MANUAL
Page 7 and 8: REV A (05-01-09)INSTALLATION MANUAL
Page 15 and 16: REV (-01-)INSTALLATION MANUAL - D5
Page 19: REV C (10-01-10)INSTALLATION MANUAL
Page 29 and 30: REV C (10-01-10)INSTALLATION MANUAL
Page 59: REV C (10-01-10)INSTALLATION MANUAL

Installation Manual - Model 5 - Tundra Process Solutions Ltd.

Create successful ePaper yourself

Delete template?

Save as template?