Installation Manual - Model 5 - Tundra Process Solutions Ltd.

More documents

Recommendations

Info

REV C (10-01-10)INSTALLATION MANUAL – D54. Support the V-frame base with two bottle jacks to lift the load off the outer skids, andthen secure the center skid to the concrete pier.NOTE: Steps 5 through 8 discuss cylinder verticality.5. Measure the side-to side and front and back verticality of the pump using a 2-footmagnetic bubble level. Place the bubble level on the cylinder wall, and also on anotherlocation, such as a smooth vertical surface on the bottom cap. See Figure 42.Figure 42. Cylinder Alignment: Verticality6. If the cylinder is not vertical, rotate the adjustable feet on each base leg as required tobring the cylinder to the vertical position. See Figure 43.Bubble levelAdjustmentfootFigure 43. Cylinder Alignment: Verticality AdjustmentSECTION 5 – INSTALLATION31
REV C (10-01-10)INSTALLATION MANUAL – D57. Perform a side-to-side measurement from the center of the cylinder to see if the feet areequidistant. Alternately, verify that the polished rod is centered on the cylinder centerline.See Figure 44.Polished rodFigure 44. Cylinder Alignment: Side-to-Side (and Front-Back)8. If the sides are not equidistant, use a chain to forcibly align the pumping unit. Alternately,a cheater bar may be applied on the skids to apply the proper torque for leverage. SeeFigure 45.ChainFigure 45. Cylinder Alignment: Side-to-Side (and Front-Back) AdjustmentSECTION 5 – INSTALLATION32
Page 1 and 2: Installation Manualfor the D5 Pumpi
Page 3 and 4: REV D (10-22-10)INSTALLATION MANUAL
Page 7 and 8: REV A (05-01-09)INSTALLATION MANUAL
Page 15 and 16: REV (-01-)INSTALLATION MANUAL - D5
Page 19 and 20: REV C (10-01-10)INSTALLATION MANUAL
Page 35: REV A (05-01-09)INSTALLATION MANUAL
Page 59: REV C (10-01-10)INSTALLATION MANUAL

Installation Manual - Model 5 - Tundra Process Solutions Ltd.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?